[Eliot Ness]

......I counted all the resistors in the chassis then compared to the schematic and come up 4 short...so far I cannot find 3of the 4.... #59 the 2.2.meg, #22 - 1000ohm and #23 - 15,000ohm.   I cannot see where they may have once been in the circuit is the other problem. The caps are #8,9,38 (I think). 

If those resistors were back in the circuit would that fix my problem or does their placement not affect the low bias, high b+?.......

It depends on exactly which caps and resistors are missing if they might be causing your problem.

I once had a Zenith chassis that had been hacked on and I had to retrace everything to make sure parts were where they should be.  I made a copy of the schematic and used colored pencils to slowly trace things out, correcting problems as I went.  It can be slow and tedious, but you need to find what is missing and try to correct it before doing much more troubleshooting.