1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Turning a Crosley 66CS into a 66TC
ccomer1955
Senior Member
****
Posts: 264
Threads: 51
Joined: Aug 2014
City: San Antonio, TX
#6

01-20-2016, 10:45 PM
That wire cover looks like a spring? If it does, then it is shielding, and the shielding is grounded to the chassis somewhere. You can find the lead inside the shielding running between the IF's padder and the junction of those two resistors. It looks to me. Others can correct me if I'm wrong on that. I'll try to look at one of my 66 chassis tomorrow to verify.
Charlie in San Antonio
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Turning a Crosley 66CS into a 66TC - by ccomer1955 - 01-20-2016, 10:45 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
unknown radio
Hello Everyone How have you been doing for so long ? Please, does anyone know this radio ? It looks like the...claude.france — 05:17 AM
Want to get my Philco working again
Hi Perry and welcome, A few notes on the 41-295/300. Probably going to need to replace some of the failing rubber coa...Radioroslyn — 11:23 PM
Want to get my Philco working again
Just one question, Perry. You do know that the NFC North is confirmed LION(s) Territory!?!?GarySP — 09:44 PM
Want to get my Philco working again
There are actually quite the host of parts websites available! There’s Mouser, Digikey, etc. for general electronics com...jrblasde — 09:44 PM
Want to get my Philco working again
Thank you all for the replies. I’ve gotten into old stereos too so soldering isn’t too hard. Good to hear I can get the ...Gbtr6 — 08:23 PM
Want to get my Philco working again
I have one of those that I restored. Not a bad sounding/performing radio. Needs new socket and all new capacitors.rfeenstra — 06:22 PM
Want to get my Philco working again
Welcome to the Phorum, Perry. Your console is a 41-295X. You can access the schematic in our Philco Service found at t...GarySP — 06:21 PM
Want to get my Philco working again
Welcome to the Phorum. The reason the tube broke is probably because of those two gold helmets on top :PRodB — 05:37 PM
Want to get my Philco working again
See, the model, then go to, go to Philco, put the model in, open the document, locate the tube, locate it in the sch. Th...morzh — 03:23 PM
Want to get my Philco working again
Hi all, I have an old Philco radio that i remember fondly from my younger days. It sat out on the porch of my dad's a...Gbtr6 — 03:14 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)