[onlyrick]

Hello and Thanks
I think I will try and change those two caps under the tuner and switch that resistor
take out the 190 K I put in and put in a 490 K.Those caps are very hard to get at,
when I look at them and try to follow the wires ,the bottom ones seem easy on
one it goes to the wafer switch and one goes to the chassis but on the top it is
very hard to follow,can anyone tell me do they both go to the bottom of the
tuner then off to the top caps on the 6K7 tube and the 6A8,if so I could attach
a wire at the tuner and feed it to the end of the cap,would be much better for me
to solder,there is no room at all down there,and will a bad cap work great then
stop and then work again ?,thanks again for any help this set is a great looker
and player,all the very best Rick