Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

37-650 Simple Questions
#9

Well, I've had her up and running for a couple hours now: while she is reasonably volumned, I am wondering if she may be a little quiet- and if so, how would I go about rectifying this? I found(before I added a rough wire antenna along the wall) that if I touched the top terminal of the 6A8G Det-Osc tube, the volume would pick up. With regard to the tubes, I replaced one of the two 6F6G tubes- and the other is a 6F6GT. And I seem to recall it(the GT) being a touch weak. Could this be the cause of lower than optimum volume?

All switches seem ok- I get nice tone change with the tone control.

AM and the first SW band seem fine- couldn't find anything on the top SW band, but I will try later in the day. With the antenna(just a long wire attached to the 1 terminal, and running between 6 and 8 feet high, about 30' long) in place, I get all sorts of stations- I found a Buffalo, NY station about 1520, which plays old stuff. I am outside of Philadelphia, so I know I'm catching a good signal.

I am pretty sure my Shadow Meter is not operating properly- I read through the information on Chuck's site, but I see no part which would operate as described in the way of a mgnetically induced flap- I am of the opinion it has been removed from the unit for some reason. All I get for display from it is a nice bar of light above the dial.

The dial lamp seems to be operating nicely- I like the way it back glows and has the well defined indicator line.

Anyway, any suggestions to how to inprove performance greatly appreciated.(All caps, bakelites, resistors, most wires, replaced or rebuilt)

Thanks!
Scott

Old Cars, Old Radios, Old Pipes and Young Women... What more is there?


Messages In This Thread
37-650 Simple Questions - by Robbie Roberts - 12-22-2005, 06:29 PM
[No subject] - by Ron Ramirez - 12-22-2005, 08:29 PM
Update on 37-650 Project - by Robbie Roberts - 01-03-2006, 03:07 AM
[No subject] - by Terry Burns - 01-03-2006, 07:55 AM
DMM? - by Robbie Roberts - 01-03-2006, 09:16 AM
[No subject] - by Chuck Schwark - 01-03-2006, 09:58 AM
[No subject] - by Robbie Roberts - 01-03-2006, 12:59 PM
ITS ALIVE!!! - by Robbie Roberts - 01-04-2006, 01:05 AM
Seems OK- restoration report - by Robbie Roberts - 01-04-2006, 03:21 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-345 Restoration/Repair
"Your radio tubes get these voltages from the power transformer secondary windings. The A voltage is supplied by th...osanders0311 — 01:40 PM
Philco 42-345 Restoration/Repair
Please correct me if I am wrong, while working on this radio I noticed under the chassis where the bottom of the tubes p...osanders0311 — 01:28 PM
Philco 42-345 Restoration/Repair
"BTW there's a 2.2k resistor from B+ to one of the XXL tubes so you have to identify those resistors before you rep...osanders0311 — 01:04 PM
Philco 42-345 Restoration/Repair
BTW there's a 2.2k resistor from B+ to one of the XXL tubes so you have to identify those resistors before you replace t...RodB — 11:08 AM
Philco 42-345 Restoration/Repair
Okey dokey, let's get on the wayback machine. Back when radios were running on batteries, they were powered by three DC ...RodB — 10:34 AM
Philco 46-1209 strange behavior
Meter is a DMM (Brymen BM-257 to be exact) Voltage being measured to the chassis Yep, just double-checked 'emsq65 — 10:22 AM
I'm starting to restore a Philco 16X, I need spare parts. Help me find it
Hi Peter, As for the spkr what you are looking for is a U-2 spkr. The H style spkrs are not as robust as the U models. ...Radioroslyn — 07:40 AM
Philco 42-345 Restoration/Repair
Hello Rod,  Honestly I am not sure what you mean by B+ on the schematic, I am still trying to figure it out as I hadn...osanders0311 — 05:56 PM
Philco 46-1209 strange behavior
What kind of meter is it? Relative to what is the voltage being measured? Are the AC line filter caps C53A/B hooked up...morzh — 10:47 AM
Philco 42-345 Restoration/Repair
Hi, what I'm seeing on the schematic is one wire from the output transformer goes to B+ and the other goes to the 7B5 pl...RodB — 10:42 AM

[-]
Who's Online
There are currently 877 online users. [Complete List]
» 3 Member(s) | 874 Guest(s)
AvatarAvatarAvatar

>