philco 48-1283 wiring issue

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

#13

05-03-2009, 12:43 AM

thanks for the information, I have found the source of my problems. The schematic shows r101 and r 303 as 8200r yet the parts list show these as 82,000 and 82,000 which I ordered and used. I replaced these with the orginals ( ie 8200R) and there it is , it works!!. I still have a slight buz and the test points read slightly high, but this may be due to the old resistors: I await replacements. Also, I plan on constructing a new AM antenna to be installed within the cabinet. Thanks for the information. My next project is a reconstruction of a Model 46-1201 "Bing Crosby" AM-Phonograph. Wish me luck.

« Next Oldest | Next Newest »

Messages In This Thread

philco 48-1283 wiring issue - by Guest - 04-24-2009, 05:31 PM

Re: philco 48-1283 wiring issue - by planigan - 04-24-2009, 11:34 PM

Re: philco 48-1283 wiring issue - by Texasrocker - 04-25-2009, 03:52 AM

Re: philco 48-1283 wiring issue - by Guest - 04-25-2009, 10:06 AM

Re: philco 48-1283 wiring issue - by codefox1 - 04-25-2009, 01:23 PM

Re: philco 48-1283 wiring issue - by planigan - 04-25-2009, 08:12 PM

Re: philco 48-1283 wiring issue - by Guest - 04-26-2009, 12:07 AM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 01:36 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 01:52 PM

Re: philco 48-1283 wiring issue - by Guest - 04-26-2009, 04:45 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 06:47 PM

Re: philco 48-1283 wiring issue - by planigan - 04-26-2009, 11:10 PM

Re: philco 48-1283 wiring issue - by Guest - 05-03-2009, 12:43 AM

Re: philco 48-1283 phono cartridge replacement - by Guest - 05-06-2009, 04:36 PM

Re: philco 48-1283 wiring issue - by Bob - 05-06-2009, 08:41 PM

Re: philco 48-1283 wiring issue - by planigan - 05-08-2009, 01:13 AM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Gilfillan Brothers Car Radio?
Hi everyone, Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM

Who's Online

There are currently 2935 online users. [Complete List]
» 1 Member(s) | 2934 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me