1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)
Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Beautiful Zenith 5S127 from SARS swap meet
mikethedruid
Banned
Posts: 1,824
Threads: 114
Joined: Jul 2014
City: Sneedville, TN
#4

02-22-2016, 10:25 PM
I'd say it is most likely just dirt or dust particles in the tuning condenser. This is the most common cause. When you have the chassis out try cleaning between each plate with a thin pipe cleaner with the condensers open. this should pick up any dirt and dust. Be very careful not to bend the plates.
Find
« Next Oldest | Next Newest »


Messages In This Thread
RE: Beautiful Zenith 5S127 from SARS swap meet - by mikethedruid - 02-22-2016, 10:25 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
unknown radio
Hello Everyone How have you been doing for so long ? Please, does anyone know this radio ? It looks like the...claude.france — 05:17 AM
Want to get my Philco working again
Hi Perry and welcome, A few notes on the 41-295/300. Probably going to need to replace some of the failing rubber coa...Radioroslyn — 11:23 PM
Want to get my Philco working again
Just one question, Perry. You do know that the NFC North is confirmed LION(s) Territory!?!?GarySP — 09:44 PM
Want to get my Philco working again
There are actually quite the host of parts websites available! There’s Mouser, Digikey, etc. for general electronics com...jrblasde — 09:44 PM
Want to get my Philco working again
Thank you all for the replies. I’ve gotten into old stereos too so soldering isn’t too hard. Good to hear I can get the ...Gbtr6 — 08:23 PM
Want to get my Philco working again
I have one of those that I restored. Not a bad sounding/performing radio. Needs new socket and all new capacitors.rfeenstra — 06:22 PM
Want to get my Philco working again
Welcome to the Phorum, Perry. Your console is a 41-295X. You can access the schematic in our Philco Service found at t...GarySP — 06:21 PM
Want to get my Philco working again
Welcome to the Phorum. The reason the tube broke is probably because of those two gold helmets on top :PRodB — 05:37 PM
Want to get my Philco working again
See, the model, then go to, go to Philco, put the model in, open the document, locate the tube, locate it in the sch. Th...morzh — 03:23 PM
Want to get my Philco working again
Hi all, I have an old Philco radio that i remember fondly from my younger days. It sat out on the porch of my dad's a...Gbtr6 — 03:14 PM

[-]
Who's Online
There are currently 262 online users. [Complete List]
» 1 Member(s) | 261 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Other Radios (Non-Philco)