1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-116 lights
murf
Senior Member
****
Posts: 668
Threads: 144
Joined: Jun 2011
City: Elko,MN.
#10

02-28-2016, 11:10 AM
Got my lights and rebuilt them yesterday.
Hooked up to a 6 volt battery and they all lit.
Tried hooking up to the 2 wires coming from chassis and got nothing.
Looks like these 2 wires are coming from a terminal block that is wired to the magnetic tuning switch.
Am I looking at a bad switch?
Does work to control magnetic tuning.
I am at a loss here.
Any ideas?
murf
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-116 lights - by murf - 01-31-2016, 05:09 PM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 12:46 AM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 07:47 PM
RE: Philco 37-116 lights - by murf - 02-01-2016, 09:04 PM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 09:35 PM
RE: Philco 37-116 lights - by murf - 02-02-2016, 09:35 PM
RE: Philco 37-116 lights - by Ron Ramirez - 02-24-2016, 10:48 PM
RE: Philco 37-116 lights - by murf - 02-28-2016, 11:10 AM
RE: Philco 37-116 lights - by Ron Ramirez - 02-28-2016, 11:51 AM
RE: Philco 37-116 lights - by murf - 02-28-2016, 12:41 PM
RE: Philco 37-116 lights - by 462ron - 02-28-2016, 02:30 PM
RE: Philco 37-116 lights - by murf - 02-28-2016, 05:39 PM
RE: Philco 37-116 lights - by PhilcoJohn - 03-02-2016, 08:06 PM
philco 37-116 lights - by murf - 02-24-2016, 06:32 PM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
Hello Rob. I've also heard of soaking the tuning cap in automatic transmission fluid. This was an old trick we used to...GarySP — 06:14 PM
Rusty Tuning Condenser
Gary, I once had a tuning cap that had a thick coat of kitchen grease and grime. So I had heard about brake cleaner bei...RodB — 06:03 PM
Rusty Tuning Condenser
I've put tuning caps with mica removed and vanes wide open in the dishwasher and ran through a cycle. When the dishwash...GarySP — 05:42 PM
Rusty Tuning Condenser
I do not think Philco 91 used pot metal for the tuning cap. Also, in 1930-s pot metal did not have iron, being mostly co...morzh — 04:56 PM
38-10T chassis Restoration begins
Rich do you dunk the whole razor in there with it turned on to get a good mix? :lol:dconant — 04:48 PM
Rusty Tuning Condenser
David, RodB says to watch out for pot metal as it might dissolve in vinegar. I think there might be some in there. I thi...dconant — 04:40 PM
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM

[-]
Who's Online
There are currently 3309 online users. [Complete List]
» 2 Member(s) | 3307 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration