1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-116 lights
Ron Ramirez
Silent Key
*****
Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana
#11

02-28-2016, 11:51 AM
Have you tried to clean the Magnetic Tuning switch?

Those are known for going bad. They have two sets of contacts; one that actually switches the Magnetic Tuning circuitry in and out, and the other that turns the lamps on and off. One or the other often gets dirty over the decades. Sometimes cleaning can fix it; sometimes not.
--
Ron Ramirez
Ferdinand IN
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-116 lights - by murf - 01-31-2016, 05:09 PM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 12:46 AM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 07:47 PM
RE: Philco 37-116 lights - by murf - 02-01-2016, 09:04 PM
RE: Philco 37-116 lights - by Nathan Slingerland - 02-01-2016, 09:35 PM
RE: Philco 37-116 lights - by murf - 02-02-2016, 09:35 PM
RE: Philco 37-116 lights - by Ron Ramirez - 02-24-2016, 10:48 PM
RE: Philco 37-116 lights - by murf - 02-28-2016, 11:10 AM
RE: Philco 37-116 lights - by Ron Ramirez - 02-28-2016, 11:51 AM
RE: Philco 37-116 lights - by murf - 02-28-2016, 12:41 PM
RE: Philco 37-116 lights - by 462ron - 02-28-2016, 02:30 PM
RE: Philco 37-116 lights - by murf - 02-28-2016, 05:39 PM
RE: Philco 37-116 lights - by PhilcoJohn - 03-02-2016, 08:06 PM
philco 37-116 lights - by murf - 02-24-2016, 06:32 PM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
Hello Rob. I've also heard of soaking the tuning cap in automatic transmission fluid. This was an old trick we used to...GarySP — 06:14 PM
Rusty Tuning Condenser
Gary, I once had a tuning cap that had a thick coat of kitchen grease and grime. So I had heard about brake cleaner bei...RodB — 06:03 PM
Rusty Tuning Condenser
I've put tuning caps with mica removed and vanes wide open in the dishwasher and ran through a cycle. When the dishwash...GarySP — 05:42 PM
Rusty Tuning Condenser
I do not think Philco 91 used pot metal for the tuning cap. Also, in 1930-s pot metal did not have iron, being mostly co...morzh — 04:56 PM
38-10T chassis Restoration begins
Rich do you dunk the whole razor in there with it turned on to get a good mix? :lol:dconant — 04:48 PM
Rusty Tuning Condenser
David, RodB says to watch out for pot metal as it might dissolve in vinegar. I think there might be some in there. I thi...dconant — 04:40 PM
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM

[-]
Who's Online
There are currently 2814 online users. [Complete List]
» 1 Member(s) | 2813 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration