Thread Rating:
  • 1 Vote(s) - 4 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Beautiful Zenith 5S127 from SARS swap meet
#15

I have always liked the sound of the Zenith radios from the era. They seemed to me like they had a lot better fidelity or something, maybe a little better bass, from a smaller radio. I think they used a little bigger speaker or something. Some of my first radios were Zenith, a tabletop 1950's model and a floor model I purchase when I was around 7 or 8 years old. They sounded much better than most other radios I had heard at that time. I still have both of them and hope to restore them once I get my radio room finished.

If I could find the place called "Somewhere", I could find "Anything" Icon_confused

Tim

Jesus cried out and said, "Whoever believes in me , believes not in me but in him who sent me" John 12:44





Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
unknown radio
Hello Everyone How have you been doing for so long ? Please, does anyone know this radio ? It looks like the...claude.france — 05:17 AM
Want to get my Philco working again
Hi Perry and welcome, A few notes on the 41-295/300. Probably going to need to replace some of the failing rubber coa...Radioroslyn — 11:23 PM
Want to get my Philco working again
Just one question, Perry. You do know that the NFC North is confirmed LION(s) Territory!?!?GarySP — 09:44 PM
Want to get my Philco working again
There are actually quite the host of parts websites available! There’s Mouser, Digikey, etc. for general electronics com...jrblasde — 09:44 PM
Want to get my Philco working again
Thank you all for the replies. I’ve gotten into old stereos too so soldering isn’t too hard. Good to hear I can get the ...Gbtr6 — 08:23 PM
Want to get my Philco working again
I have one of those that I restored. Not a bad sounding/performing radio. Needs new socket and all new capacitors.rfeenstra — 06:22 PM
Want to get my Philco working again
Welcome to the Phorum, Perry. Your console is a 41-295X. You can access the schematic in our Philco Service found at t...GarySP — 06:21 PM
Want to get my Philco working again
Welcome to the Phorum. The reason the tube broke is probably because of those two gold helmets on top :PRodB — 05:37 PM
Want to get my Philco working again
See, the model, then go to, go to Philco, put the model in, open the document, locate the tube, locate it in the sch. Th...morzh — 03:23 PM
Want to get my Philco working again
Hi all, I have an old Philco radio that i remember fondly from my younger days. It sat out on the porch of my dad's a...Gbtr6 — 03:14 PM

[-]
Who's Online
There are currently no members online.

>