1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
37-650 Success- and questions...
Robbie Roberts
Member
***
Posts: 147
Threads: 28
Joined: Nov 2005
#3

01-04-2006, 12:21 PM
Yes- with the antenna connected, it still has reasonably low volume- I have one good, strong local(about 15 mile) signal(1210AM- used to be WCAU) which comes in moderately loud, but everything else requires almost full volume. I might take a look at my speaker transformers- it looks like someone was monkeying with them at some point.


I don't have any signal generator, etc. test equipment, but I am waiting on word from a guy in Delaware who does recaps, to see if he'd tune her up, now the leg work is done...

Scott
Old Cars, Old Radios, Old Pipes and Young Women... What more is there?
Find
« Next Oldest | Next Newest »


Messages In This Thread
[No subject] - by Jerry Huelsbeck - 01-04-2006, 12:16 PM
[No subject] - by Robbie Roberts - 01-04-2006, 12:21 PM
[No subject] - by Jerry Huelsbeck - 01-04-2006, 12:37 PM
[No subject] - by Robbie Roberts - 01-05-2006, 09:11 AM
[No subject] - by Chuck Schwark - 01-05-2006, 09:52 AM
[No subject] - by Robbie Roberts - 01-05-2006, 09:26 PM
[No subject] - by Robbie Roberts - 01-11-2006, 07:16 PM
Tube issue? - by Robbie Roberts - 01-12-2006, 07:49 PM
[No subject] - by Ron Ramirez - 01-12-2006, 08:22 PM
[No subject] - by Robbie Roberts - 01-12-2006, 08:30 PM



Users browsing this thread: 4 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 4895 online users. [Complete List]
» 1 Member(s) | 4894 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration