Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Zenith C725 help!
#2

Hi Dave,
You'll find the service info here: http://www.rsp-italy.it/Electronics/Radi...n/1960.pdf
on page 174.
Check the dc voltage at the + side of the rectifier should see 100v or better.

Terry


Messages In This Thread
Zenith C725 help! - by TheUniversalDave1 - 03-07-2016, 12:32 AM
RE: Zenith C725 help! - by Radioroslyn - 03-07-2016, 07:12 AM
RE: Zenith C725 help! - by TV MAN - 03-07-2016, 12:13 PM
RE: Zenith C725 help! - by TheUniversalDave1 - 03-07-2016, 02:56 PM
RE: Zenith C725 help! - by David - 03-07-2016, 09:06 PM
RE: Zenith C725 help! - by TheUniversalDave1 - 03-07-2016, 11:09 PM
RE: Zenith C725 help! - by doc612 - 03-09-2016, 10:33 PM
RE: Zenith C725 help! - by TheUniversalDave1 - 03-10-2016, 10:34 AM
RE: Zenith C725 help! - by TV MAN - 03-11-2016, 10:37 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>