Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Pros and Cons of Refinishing the 511 Series cabinets
#25

This is a scan of the shield from a model 513 serial 002114. The serial number on the shield is also stamped on the chassis, directly to the rear of the shield. This shield is held in place by 4 easily accessable screws. It can therefore be discarded, the cabinet stripped and re-painted in any of the 4 designs, and thus sold as the real thing, any model. The non-collector seeing a fake in an antique store would never suspect.

I am aware of a collector with superior painting skills who is in fact producing "faux" cabinets, for others and himself, but swears he would never mis-represent them as being originals. However once out of his hands and into another's, there's no longer any control on the radio's fate. But only time will tell . . .

Best regards, Michael P.

"Ice cream has no bones"


Messages In This Thread
Re: Pros and Cons of Refinishing the 511 Series cabinets - by Philco1928 - 05-16-2009, 05:02 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
Outstanding work indeed. I wish I could come up with solutions like this.slford310 — 11:16 PM
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM

[-]
Who's Online
There are currently no members online.

>