1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Heath IG-102 signal generator
hollowstate
Junior Member
**
Posts: 14
Threads: 4
Joined: Mar 2009
#3

05-19-2009, 11:28 PM
First, thanks for your consideration! I really thought this might be a kind of dead-end. I don't have a picture of it handy, but it's the shaft-in-shaft type (not much to see) - built into the cap itself, with a twist. The main shaft is 3/8" and the vernier is 1/4" instead of 1/4" and 1/8" as many are. You mention there are ways to disassemble it, but I'm running low on dynamite - are there other ways?
Until next time,
Stirling KC0NXM.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Heath IG-102 signal generator - by hollowstate - 05-19-2009, 09:58 PM
Re: Heath IG-102 signal generator - by exray - 05-19-2009, 10:57 PM
Re: Heath IG-102 signal generator - by hollowstate - 05-19-2009, 11:28 PM
Re: Heath IG-102 signal generator - by exray - 05-20-2009, 12:10 AM
Re: Heath IG-102 signal generator - by exray - 05-20-2009, 09:47 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently 4744 online users. [Complete List]
» 4 Member(s) | 4740 Guest(s)
AvatarAvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Various and Sundry Categories
  3. Test Equipment