Tube Shield Finish

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Tube Shield Finish

Derek D
Junior Member

Posts: 25
Threads: 10
Joined: Dec 2005

01-05-2006, 12:59 PM

I thought they were supposed to be shiny. Must have been some type of plating. Maybe nickel?

Find

« Next Oldest | Next Newest »

Messages In This Thread

Tube Shield Finish - by Derek D - 01-04-2006, 11:24 AM

[No subject] - by Ron Ramirez - 01-05-2006, 12:49 PM

[No subject] - by Derek D - 01-05-2006, 12:59 PM

[No subject] - by 49Stude63 - 01-05-2006, 01:40 PM

[No subject] - by Terry Judkins - 01-05-2006, 10:06 PM

[No subject] - by Guest - 01-06-2006, 02:46 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached. I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM

Who's Online

There are currently 7224 online users. [Complete List]
» 4 Member(s) | 7220 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me