38-116 speaker

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

38-116 speaker

sam
Phorum Expert

Posts: 2,572
Threads: 337
Joined: Jun 2013
City: lawrenceville nj

04-20-2016, 12:00 PM

hey guys
I have a 38-116 speaker. cone has small tear other then that great
NO voice coil on cone bad thought rewire it ?
has any one had luck trying to get paper cone off speaker frame
with out tearing it ?

thanks sam

Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2

Find

« Next Oldest | Next Newest »

Messages In This Thread

38-116 speaker - by sam - 04-20-2016, 12:00 PM

RE: 38-116 speaker - by Radioroslyn - 04-20-2016, 04:19 PM

RE: 38-116 speaker - by Ron Ramirez - 04-20-2016, 06:15 PM

RE: 38-116 speaker - by sam - 04-20-2016, 10:44 PM

RE: 38-116 speaker - by Radioroslyn - 04-21-2016, 07:25 AM

RE: 38-116 speaker - by sam - 04-21-2016, 12:34 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me