PT 7 Volume issue

Thread Rating:

PT 7 Volume issue

klondike98
Phorum Moderator

Posts: 5,088
Threads: 270
Joined: Nov 2012
City: Wilsonville State, Province, Country: OR

05-08-2016, 05:53 PM

Welcome to the Phorum!
Icon_wave

« Next Oldest | Next Newest »

Messages In This Thread

PT 7 Volume issue - by karlm - 05-07-2016, 08:20 AM

RE: PT 7 Volume issue - by morzh - 05-07-2016, 09:41 AM

RE: PT 7 Volume issue - by karlm - 05-08-2016, 11:49 AM

RE: PT 7 Volume issue - by klondike98 - 05-08-2016, 05:53 PM

RE: PT 7 Volume issue - by karlm - 05-16-2016, 09:40 AM

RE: PT 7 Volume issue - by morzh - 05-16-2016, 09:50 AM

RE: PT 7 Volume issue - by karlm - 05-30-2016, 12:50 PM

Users browsing this thread: 3 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4012 online users. [Complete List]
» 3 Member(s) | 4009 Guest(s)