Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA Q-103 tube ?
#6

Looks as though I'm going in circles, After the alignment all I get are whistles when I try and tune. So I check voltages and I seem to have a problem with the 12SK7 unless it's a misprint. All other voltages are good on the 12SK7 I get
pins 1,3,5 are tied together and go to chassis
pin 2, 7 are heaters I get 23acv and 34acv
pin 4, -.6vdc
pin 6 88vdc
pin 8 83vdc

Print says Pin 3,4 should have 82vdc???
Tired of chasing my tail! ( to old)


Messages In This Thread
RCA Q-103 tube ? - by Eric - 05-06-2016, 02:00 PM
RE: RCA Q-103 tube ? - by Phlogiston - 05-06-2016, 02:35 PM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-06-2016, 11:12 PM
RE: RCA Q-103 tube ? - by Eric - 05-08-2016, 08:42 AM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-08-2016, 06:34 PM
RE: RCA Q-103 tube ? - by Eric - 05-11-2016, 02:35 PM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-11-2016, 03:32 PM
RE: RCA Q-103 tube ? - by Eric - 05-12-2016, 02:20 PM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-12-2016, 02:57 PM
RE: RCA Q-103 tube ? - by Eric - 05-13-2016, 07:58 AM
RE: RCA Q-103 tube ? - by Eric - 05-17-2016, 10:02 AM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-17-2016, 03:33 PM
RE: RCA Q-103 tube ? - by Eric - 05-19-2016, 03:51 PM
RE: RCA Q-103 tube ? - by Eric - 05-18-2016, 06:19 PM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-18-2016, 06:54 PM
RE: RCA Q-103 tube ? - by Eric - 05-19-2016, 09:45 AM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-19-2016, 05:16 PM
RE: RCA Q-103 tube ? - by Eric - 05-20-2016, 10:55 AM
RE: RCA Q-103 tube ? - by Radioroslyn - 05-20-2016, 08:16 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2970 online users. [Complete List]
» 2 Member(s) | 2968 Guest(s)
AvatarAvatar

>