1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration

Welcome Guest! Be sure you know and follow the Phorum Rules before posting. Thank you and Enjoy! (January 12) x

Thread Closed
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco Wirewound Resistor Question
Geoff
Senior Member
****
Posts: 479
Threads: 73
Joined: Mar 2012
City: Riverside, CA
#1

05-18-2016, 06:05 PM
Hi Guys,

I have a wirewound resistor in my Philco 640 (P/N 33-3208, #78 in the schematic) .  It is listed as 60 ohms and 100 ohms.  It's pretty cruddy looking and even if it tests good I would like to replace it.  I checked Chuck's site and some Philco part catalogs I've found on the internet but can't find any information on wattage.  What would you guys recommend?  Schematic is attached.

[Image: http://i12.photobucket.com/albums/a241/J...cexuli.jpg]

Thanks,
Geoff


Attached Files
.pdf Philco 640 Schematic.pdf Size: 644.49 KB  Downloads: 181
(This post was last modified: 06-01-2016, 11:26 AM by Geoff.)
Find
« Next Oldest | Next Newest »
Thread Closed


Messages In This Thread
Philco Wirewound Resistor Question - by Geoff - 05-18-2016, 06:05 PM
RE: Philco Wirewound Resistor Question - by morzh - 05-18-2016, 07:32 PM
RE: Philco Wirewound Resistor Question - by Geoff - 05-18-2016, 08:02 PM
RE: Philco Wirewound Resistor Question - by morzh - 05-18-2016, 10:14 PM
RE: Philco Wirewound Resistor Question - by gregb - 05-18-2016, 09:44 PM
RE: Philco Wirewound Resistor Question - by Geoff - 05-20-2016, 02:42 PM
RE: Philco Wirewound Resistor Question - by gregb - 05-20-2016, 05:19 PM
RE: Philco Wirewound Resistor Question - by Geoff - 05-21-2016, 02:00 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 91 Restore Code ??
Can someone tell me if my 42 tubes are connected triode or pentode in fixed or cathode bias? How could I tell by looking...dconant — 10:47 AM
Philco 40-120C Restoration
Hello David, that is great news about the tubes source being local ! Sounds like you got good start on the radio . ...radiorich — 09:41 AM
An attempt to remove the Field Coil from a G speaker
Mike; I've only run into a speaker with an open filed coil twice, and they were on newer speakers from the 1940s. One ...Arran — 12:48 AM
An attempt to remove the Field Coil from a G speaker
Arran Yes, this is my plan for now and what do I got to lose, this is not even the speaker from this radio, but one o...morzh — 10:44 PM
An attempt to remove the Field Coil from a G speaker
Mike;  I would unwrap the field coil, and see if maybe there a break near one of the ends, like where the coil wire att...Arran — 10:23 PM
An attempt to remove the Field Coil from a G speaker
...and this is what I did. I fed a little LT into the screwholes with a small brush, and a little on the rim next to the...morzh — 09:52 PM
Philco 40-120C Restoration
I combined the two 40-120C threads together as we like to keep the discussion of the same radio together. It helps with...klondike98 — 09:36 PM
Philco 40-120C Weak, Distorted Ouput
Just checked were I buy tubes price is four dollars. So living in Florid we have a local source for tubes. David    David — 09:14 PM
Philco 40-120C Weak, Distorted Ouput
The higher voltage may be due to higher mains voltage. My mains run 120-125AC when the set was new mains would be 110-11...David — 09:09 PM
Philco 40-120C Weak, Distorted Ouput
Thank you for your reply. I pulled a speaker from a Philco 41-221 and received the same result. I used a signal tracer t...bluecap — 08:45 PM

[-]
Who's Online
There are currently 2392 online users. [Complete List]
» 3 Member(s) | 2389 Guest(s)
AvatarAvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration