I neeeeed opinions..

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

I neeeeed opinions..

Arran
Phorum Expert

Posts: 4,707
Threads: 51
Joined: Sep 2008
City: Sandwick, BC, CA

#15

05-19-2016, 12:31 AM

In looking at those pictures I hope that the veneer on the right front curve is not cracked across the grain. It's up to you of course but I would not pay $90 for it, or any other rubber wire and Tenite plastic special, if it were not for the beam of light changer and maybe an old FM band in the radio, it wouldn't be of much interest.
Regards
Arran

Find

« Next Oldest | Next Newest »

Messages In This Thread

I neeeeed opinions.. - by OldRestorer - 05-17-2016, 06:13 PM

RE: I neeeeed opinions.. - by sam - 05-17-2016, 06:55 PM

RE: I neeeeed opinions.. - by Radioroslyn - 05-17-2016, 07:03 PM

RE: I neeeeed opinions.. - by Joe Rossi - 05-17-2016, 07:12 PM

RE: I neeeeed opinions.. - by OldRestorer - 05-17-2016, 07:27 PM

RE: I neeeeed opinions.. - by Ron Ramirez - 05-17-2016, 08:21 PM

RE: I neeeeed opinions.. - by morzh - 05-17-2016, 07:46 PM

RE: I neeeeed opinions.. - by Phlogiston - 05-18-2016, 01:51 AM

RE: I neeeeed opinions.. - by Ron Ramirez - 05-18-2016, 09:50 AM

RE: I neeeeed opinions.. - by OldRestorer - 05-18-2016, 10:57 AM

RE: I neeeeed opinions.. - by Phlogiston - 05-18-2016, 05:38 PM

RE: I neeeeed opinions.. - by OldRestorer - 05-18-2016, 07:01 PM

RE: I neeeeed opinions.. - by morzh - 05-18-2016, 07:37 PM

RE: I neeeeed opinions.. - by KCMike - 05-18-2016, 07:37 PM

RE: I neeeeed opinions.. - by Arran - 05-19-2016, 12:31 AM

RE: I neeeeed opinions.. - by sam - 05-19-2016, 02:15 PM

RE: I neeeeed opinions.. - by morzh - 05-19-2016, 03:06 PM

RE: I neeeeed opinions.. - by OldRestorer - 05-19-2016, 04:03 PM

RE: I neeeeed opinions.. - by sam - 05-19-2016, 07:48 PM

RE: I neeeeed opinions.. - by Ron Ramirez - 05-19-2016, 08:19 PM

RE: I neeeeed opinions.. - by morzh - 05-19-2016, 08:10 PM

RE: I neeeeed opinions.. - by OldRestorer - 05-20-2016, 08:08 AM

RE: I neeeeed opinions.. - by morzh - 05-20-2016, 09:14 AM

RE: I neeeeed opinions.. - by Phlogiston - 05-20-2016, 11:01 AM

RE: I neeeeed opinions.. - by morzh - 05-20-2016, 11:17 AM

RE: I neeeeed opinions.. - by OldRestorer - 05-21-2016, 05:42 PM

RE: I neeeeed opinions.. - by morzh - 05-21-2016, 06:58 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM
Philco 60 Squealing
I have taken out the 2nd IF and found a problem or not. I believe the coils are litz wire. There is a very small strand ...dconant — 02:13 PM
Philco 6K7
I am restoring a Philco 37-60. The am reception is very good, but the shortwave is very weak. Run 6 Philco removes the g...bobbyd1200 — 01:35 PM

Who's Online

There are currently 4703 online users. [Complete List]
» 4 Member(s) | 4699 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me