Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Bakelite capacitor holders
#8

Yep, that was the bypass in 38-12.

And in 37-116 all blocks (quite a few) had eyelets filled. Wasn't too bad, but this does complicate the process just a little.

People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.


Messages In This Thread
Bakelite capacitor holders - by Eric Smith - 05-18-2016, 09:24 PM
RE: Bakelite capacitor holders - by morzh - 05-18-2016, 10:24 PM
RE: Bakelite capacitor holders - by Steve Davis - 05-18-2016, 11:35 PM
RE: Bakelite capacitor holders - by Ron Ramirez - 05-19-2016, 06:09 AM
RE: Bakelite capacitor holders - by klondike98 - 05-19-2016, 08:03 AM
RE: Bakelite capacitor holders - by Eric Smith - 05-19-2016, 04:07 PM
RE: Bakelite capacitor holders - by morzh - 05-19-2016, 08:31 AM
RE: Bakelite capacitor holders - by Ron Ramirez - 05-19-2016, 08:40 AM
RE: Bakelite capacitor holders - by morzh - 05-19-2016, 08:47 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM

[-]
Who's Online
There are currently no members online.

>