Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5

philco 37-630 console cap value
#2

Welcome to the Phorum!
Icon_wave 

30-4317 is a 0.008 uF cap.  I found it listed in the 38-620 schematic.  Check where the cap is located in the circuit, I'll bet its cap#56 and they just used a different version of the .008 cap.  Part numbers were changing frequently.

The 3793DG bakelite block cap is #67, the line filters, on the schematic and should have two Y2 safety caps replace the two 0.015 uF caps that are in the block.  


Messages In This Thread
RE: philco 37-630 console cap value - by klondike98 - 05-23-2016, 08:10 AM
RE: philco 37-630 console cap value - by morzh - 05-23-2016, 08:15 AM
RE: philco 37-630 console cap value - by morzh - 05-23-2016, 08:44 AM
RE: philco 37-630 console cap value - by KCMike - 05-23-2016, 09:03 AM
RE: philco 37-630 console cap value - by morzh - 05-23-2016, 09:17 AM
RE: philco 37-630 console cap value - by morzh - 05-23-2016, 09:24 AM
RE: philco 37-630 console cap value - by morzh - 05-23-2016, 04:42 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM
Philco Model 80 Transformer resistance
I have a feeling the primary winding on the power transformer is bad. My resistance reading on the primary side is 9 ohm...Mike L — 07:48 PM
Rusty Tuning Condenser
I would try Naval Jelly and use a soaked pipe cleaner to get it where it needs to go.RossH — 06:56 PM
38-10T chassis Restoration begins
Hello Dconant , they sold mica to use as a insulator between transistors and their heatsinks too. Rob I will remove th...radiorich — 02:52 PM
38-10T chassis Restoration begins
Thanks for the info guys. I always wondered why the use of mica. Now I know.dconant — 01:52 PM
38-10T chassis Restoration begins
Most common plastics have a dielectric constant in the 3-4 range whereas mica is around 6. This means that even if you w...Steve D — 01:46 PM
38-10T chassis Restoration begins
It is acceptable but not desirable. Plastic is not an approved cap dielectric, and even though a reasonably thick piece...morzh — 11:52 AM

[-]
Who's Online
There are currently no members online.

>