New member

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

New member

Radioroslyn
Phorum Expert

Posts: 7,286
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

06-01-2016, 07:25 PM

Hi and welcome!
Glad to hear that you found the Phorum helpful! We also have other radio category that we may be able to help will other types of sets.

Terry

Find

« Next Oldest | Next Newest »

Messages In This Thread

New member - by JRomero - 05-31-2016, 04:49 PM

RE: New member - by Steve Davis - 05-31-2016, 07:18 PM

RE: New member - by klondike98 - 05-31-2016, 07:25 PM

RE: New member - by OldRestorer - 05-31-2016, 07:29 PM

RE: New member - by morzh - 05-31-2016, 07:30 PM

RE: New member - by Eliot Ness - 05-31-2016, 09:27 PM

RE: New member - by PhilcoJohn - 06-01-2016, 06:55 AM

RE: New member - by Joe Rossi - 06-01-2016, 07:24 PM

RE: New member - by Radioroslyn - 06-01-2016, 07:25 PM

RE: New member - by JRomero - 06-03-2016, 06:05 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4836 online users. [Complete List]
» 4 Member(s) | 4832 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me