1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Power cord, cloth clad, Radiodaze.
gregb
Senior Member
****
Posts: 599
Threads: 24
Joined: Jan 2014
City: Edmonton AB CA
#5

06-04-2016, 07:59 PM
AES has stopped supplying the exact repo cord they had. It was expensive but it was really nice with the cloth covered inner wires and the right color cotton cover.

Gregb
Find
« Next Oldest | Next Newest »


Messages In This Thread
Power cord, cloth clad, Radiodaze. - by morzh - 06-02-2016, 10:15 PM
RE: Power cord, cloth clad, Radiodaze. - by Arran - 06-04-2016, 03:40 AM
RE: Power cord, cloth clad, Radiodaze. - by morzh - 06-04-2016, 10:45 AM
RE: Power cord, cloth clad, Radiodaze. - by gregb - 06-04-2016, 07:59 PM
RE: Power cord, cloth clad, Radiodaze. - by Geoff - 07-02-2016, 09:05 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

[-]
Who's Online
There are currently 4686 online users. [Complete List]
» 2 Member(s) | 4684 Guest(s)
AvatarAvatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration