06-14-2016, 11:12 AM
terry
measure from B- to pin 1 of the 1LA5
their is no 1LA5
cleaned switches . checked over
found the 1000v cap on wrong terminal
move to right spot
replaced 117z6 . turned on vol all the way up nothing
touched center vol tap loud buzz . connected ground of meter to b- where all electrolytic grounds are
touched pins but could only get .042 v and a lighting bolt shows on my meter will change battery ?
on the 1LN5 tube (not the floating plate one) when I touch white wires loud buzz and loud hum
if I wiggle the far right 1LE3 tube static comes and goes loud and low
and I replaced all tubes with known good working ones
side note spare 40-843 chassis I have connected power to it and would you know
fire right up and picked up stations with old caps
measure from B- to pin 1 of the 1LA5
their is no 1LA5cleaned switches . checked over
found the 1000v cap on wrong terminal
move to right spotreplaced 117z6 . turned on vol all the way up nothing
touched center vol tap loud buzz . connected ground of meter to b- where all electrolytic grounds are
touched pins but could only get .042 v and a lighting bolt shows on my meter will change battery ?
on the 1LN5 tube (not the floating plate one) when I touch white wires loud buzz and loud hum
if I wiggle the far right 1LE3 tube static comes and goes loud and low
and I replaced all tubes with known good working ones
side note spare 40-843 chassis I have connected power to it and would you know
fire right up and picked up stations with old caps
Some day, and that day may never come, I will call upon you to do a service for me. But until that day, accept this justice as a gift
mafiamen2
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
