42-350 garbled sound

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

42-350 garbled sound

Joe Rossi
Senior Member

Posts: 461
Threads: 31
Joined: Sep 2009
City: Lapeer State, Province, Country: MI

06-15-2016, 07:16 PM

Greg, Did it play before the recapping? I'm sure you did the other obvious of checking connections and solder joints. Do you have enough tubes of known goodness to replace them all? You could have more than 1 bad tube. An alignment may also be a culprit. Joe

Joe

Matthew 16:26 "For what does it profit a man if he gain the whole world, yet lose his own soul?"

Find

« Next Oldest | Next Newest »

Messages In This Thread

42-350 garbled sound - by NostalgiaRadioTime - 06-15-2016, 06:56 PM

RE: 42-350 garbled sound - by Joe Rossi - 06-15-2016, 07:16 PM

RE: 42-350 garbled sound - by NostalgiaRadioTime - 06-15-2016, 08:28 PM

RE: 42-350 garbled sound - by Eliot Ness - 06-15-2016, 08:36 PM

RE: 42-350 garbled sound - by morzh - 06-15-2016, 09:02 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM
Philco 16B Parts
Hi Dan, Mike is correct, there's a lot of painted stuff on the chassis but it looks pretty good. The sm is all there,sp...Radioroslyn — 03:50 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Hi Cap'n Clock, Unfortunately, I do not have this radio. This is a shame because this should be a good performer. 2A...captainclock1988 — 03:43 PM
Philco 42-390, code 121 speaker
Using a 5W 1.5k ceramic resistor in place of the field coil and using a 4 ohm PM speaker, I was able to bring the radi...Stevelog — 02:57 PM

Who's Online

There are currently 3068 online users. [Complete List]
» 3 Member(s) | 3065 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me