Big, Bad*s*, and ugly 660L
Posts: 7,305
Threads: 270
Joined: Dec 2009
City: Roslyn Pa
Finally got the set screw out that holds the dial to the tuning cap. Twisted the tips of 2 drivers but got it. Man it was tight, squeaking as I turned it outward. Took the rest apart and cleaned it up. The reduction drive is pretty worn it feels a bit rough, cleaned it and added a bit of grease but is still a little rough. Also found that the dial lamp was the wrong one it uses a brighter bulb and the bulb in the shadowmeter is bad. Both the band mask and arrow mask were filthy! Placed an order for the bulbs as I'm out of #46 and 55's
Got it put back together.
Terry
Messages In This Thread
RE: Big, Bad*s*, and ugly 660L - by Radioroslyn - 06-22-2016, 02:44 PM
Users browsing this thread: 1 Guest(s)
|
|
Recent Posts
|
|
Rogers Majestic R-646
|
| Vlad;
I was just reminded of something else, I'm not sure why but many Rogers built sets do seem to have open primari...Arran — 04:40 PM |
|
Rogers Majestic R-646
|
| Thanks RpdB
I don't think there's much difference with interstage transformers of different models other than dimersion...Vlad95 — 03:27 PM |
|
Rogers Majestic R-646
|
| Vlad;
I looks like your set has the same problem that mine did, both a bad output transformer, and a bad audio inters...Arran — 03:21 PM |
|
Rogers Majestic R-646
|
| Ouch! Not often the secondary takes a hit. Wish there was a better solution. I have a good interstage transformer but it...RodB — 02:59 PM |
|
Rogers Majestic R-646
|
| By the way, the bypass you suggested is a rare solution in some circuits.
For example, this schematics solution is used...Vlad95 — 01:43 PM |
|
Rogers Majestic R-646
|
| No, you are wrong, because you did not know the details.
Unfortunately, only ONE winding out of six is intact in both t...Vlad95 — 01:14 PM |
|
Rogers Majestic R-646
|
| The output 45s are still in push-pull because the transformer secondary winding is still in the grid circuit providing o...RodB — 11:52 AM |
|
Rogers Majestic R-646
|
| Thanks RodB for the help.
But this is not a real solution to this situation, not even a temporary one. Because the firs...Vlad95 — 11:34 AM |
|
Philco Model 16 wiring question
|
|
I was going to check the voltages as you suggested and hooked it up to my dim bulb. It appears I have a short. The bul...bobclausen — 10:34 AM |
|
Rogers Majestic R-646
|
| You can bypass the interstage transformer by disconnecting the primary, connect a load resistor of about 10k - 20k to th...RodB — 09:40 AM |
|
Who's Online
|
There are currently 1060 online users. [Complete List]
» 5 Member(s) | 1055 Guest(s)
|
|
|
|
 
|
![[-]](https://philcoradio.com/phorum/images/bootbb/collapse.png "[-]")
