1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 48-200 Clear but faint
morzh
Odobenus rosmarus
*****
Posts: 15,825
Threads: 554
Joined: Oct 2011
City: Jackson, NJ
#14

07-11-2016, 09:25 AM
There should be nothing between 5 and 6 pins of 7A8.
That is there should be nothing connected to pin 6 other than your antenna input and the tuning cap/trimmer cap.
The special cap is connected between the common (all the cathodes) and the chassis.
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
(This post was last modified: 07-11-2016, 09:27 AM by morzh.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 09:18 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-01-2016, 10:08 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 10:57 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 11:03 PM
RE: Philco 48-200 Clear but faint - by leftwing25 - 07-02-2016, 01:06 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-01-2016, 11:28 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-04-2016, 04:03 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-06-2016, 08:53 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-08-2016, 11:37 PM
RE: Philco 48-200 Clear but faint - by David - 07-10-2016, 09:20 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-10-2016, 10:11 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-11-2016, 09:25 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 09:56 AM
RE: Philco 48-200 Clear but faint - by morzh - 07-11-2016, 11:45 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:41 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:05 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:26 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-21-2016, 07:37 AM
RE: Philco 48-200 Clear but faint - by morzh - 07-21-2016, 01:05 PM



Users browsing this thread: 9 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently 4729 online users. [Complete List]
» 1 Member(s) | 4728 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration