1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Volume regulator replacements by Philco.
morzh
Odobenus rosmarus
*****
Posts: 15,846
Threads: 555
Joined: Oct 2011
City: Jackson, NJ
#1

07-11-2016, 10:44 PM
Got one from Mark for Philco 118.

Here's something I do not understand.
The part is NOS and is a 350K pot with 75K tap plus the switch.
The pot is marked properly, same way the Philco box it came in, and the box states the values.

Now before putting it in I measured the pit, and it is 260K / 63K tap. 
I called Mark today and he explained that these replacements by Philco are well known for this large tolerance , however the tap to scale ratio of about 1/4 is observed.

My question, (and I don't doubt Mark): how come the tolerance on replacement parts is this large? What could explain that?
People who do not drink, do not smoke, do not eat red meat will one day feel really stupid lying there and dying from nothing.
(This post was last modified: 07-11-2016, 10:44 PM by morzh.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Volume regulator replacements by Philco. - by morzh - 07-11-2016, 10:44 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM
Philco 60 Squealing
I have been playing the radio for a while now and doing well. Turned it on today and all I got was a whole lot of noise....dconant — 09:39 AM
Rusty Tuning Condenser
Thanks guys. I think I'll give the Naval Jelly a try since I can better control where it goes.dconant — 09:23 AM
Philco Model 80 Transformer resistance
Just forget this number, it is useless anyway. Simply proceed with your project.morzh — 10:08 PM
Philco Model 80 Transformer resistance
My $0.02 is that it is a misprint. I tried to look up the value for the similar 84 and 37-84, and ther is no resistance...MrFixr55 — 09:51 PM
Philco Model 80 Transformer resistance
Thanks for the quick reply! Hmm...well that's good, so what am I seeing that's 1042 ohms on the schematic for the pow...Mike L — 08:46 PM
Philco Model 80 Transformer resistance
The DC resistance of the primary is 8 to 9 Ohm.morzh — 07:54 PM

[-]
Who's Online
There are currently 2902 online users. [Complete List]
» 1 Member(s) | 2901 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration