Philco 59S Help

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 59S Help

dseverson
Member

Posts: 101
Threads: 11
Joined: Nov 2014
City: Castro Valley, CA

07-13-2016, 09:16 PM

Hi, Folks. I'm back with another request for assistance. Recently, I purchased a 59s for $5 and did the recap, replaced the resistors, and rewound the coils for practice. When I fired it up, there was no sound. Before I take voltage readings (I have to get a battery for my multimeter), do any of you have suggestions or tips?

Here is a link to the schematic: http://www.nostalgiaair.org/pagesbymodel...013790.pdf

Thanks in advance.

Dave

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 59S Help - by dseverson - 07-13-2016, 09:16 PM

RE: Philco 59S Help - by morzh - 07-13-2016, 09:38 PM

RE: Philco 59S Help - by Radioroslyn - 07-13-2016, 10:33 PM

RE: Philco 59S Help - by morzh - 07-13-2016, 10:52 PM

RE: Philco 59S Help - by dseverson - 07-13-2016, 11:28 PM

RE: Philco 59S Help - by Radioroslyn - 07-13-2016, 11:50 PM

View a Printable Version

Users browsing this thread: 2 Guest(s)

Recent Posts
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM

Who's Online

There are currently 4033 online users. [Complete List]
» 2 Member(s) | 4031 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me