[Ron Ramirez]

Well, I started cutting lattice molding. I managed to get enough trim cut for the bottoms of both cabinets. Then I realized that I did not buy enough lattice molding as I only have enough left for an additional piece or two of top molding.

So...I'll be getting two more pieces of lattice molding this week.

I did a test fit and it appears I did cut the bottom trim pieces correctly (proper lengths). That's a relief!

I think my next move will be to sand down and stain the bottom molding, then apply finish. I'll save the tops and top molding for last, as I will have to cut the top molding to the proper lengths, glue them to the new top pieces, then stain followed by finish to both top/trim combinations.