Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

RCA 10K Restoration Journal
#4

g8wayg8r, Several years ago I restored a RCA 10K and everythging went well and I thought I was done. The radio was going to be a Christmas present for my daughter. Just before Christmas I was doing one last check and the audio just died. After being off for a while it worked fine , then died again. When continuity checks were done I found that a cable going from the chassis top to the bottom was the problem. The cable is wrapped and when I removed the wrapping I found that all of the wires had insulation that had rotted out and many chances for signal shorting were available. A complete cable rebuild took care of the problem and the radio is still alive and well in San Antonio. Hope you don't have the same problem.

Dave D


Messages In This Thread
RCA 10K Restoration Journal - by g8wayg8r - 07-26-2009, 10:28 PM
Re: RCA 10K Restoration Journal - by jayoungs - 07-27-2009, 09:24 AM
Re: RCA 10K Restoration Journal - by exray - 07-27-2009, 06:02 PM
Re: RCA 10K Restoration Journal - by Dave D - 07-27-2009, 10:58 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 08-04-2009, 12:27 AM
Re: RCA 10K Restoration Journal - by g8wayg8r - 08-21-2009, 11:56 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 08-23-2009, 11:51 AM
Re: RCA 10K Restoration Journal - by exray - 08-23-2009, 12:29 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 08-30-2009, 05:10 PM
Re: RCA 10K Restoration Journal - by codefox1 - 08-30-2009, 05:54 PM
Re: RCA 10K Restoration Journal - by exray - 08-30-2009, 07:50 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 08-30-2009, 08:31 PM
Re: RCA 10K Restoration Journal - by exray - 08-30-2009, 09:44 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 09-13-2009, 05:05 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 09-13-2009, 09:50 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 09-20-2009, 10:38 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 09-30-2009, 10:52 PM
Re: RCA 10K Restoration Journal - by g8wayg8r - 11-19-2009, 01:06 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

[-]
Who's Online
There are currently no members online.

>