1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 48-200 Clear but faint
Tgace459
Member
***
Posts: 130
Threads: 25
Joined: Apr 2016
City: Buffalo NY
#21

07-21-2016, 07:37 AM
Solution found. Someone had recapped this I the past. The .22 mfd cap I pulled and replaced was the problem. Checking the schematic, the cap was listed as a 22 MMFD cap. When I put a .0002 cap in there all was well.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 09:18 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-01-2016, 10:08 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 10:57 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-01-2016, 11:03 PM
RE: Philco 48-200 Clear but faint - by leftwing25 - 07-02-2016, 01:06 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-01-2016, 11:28 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-04-2016, 04:03 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-06-2016, 08:53 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-08-2016, 11:37 PM
RE: Philco 48-200 Clear but faint - by David - 07-10-2016, 09:20 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-10-2016, 10:11 PM
RE: Philco 48-200 Clear but faint - by morzh - 07-11-2016, 09:25 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 09:56 AM
RE: Philco 48-200 Clear but faint - by morzh - 07-11-2016, 11:45 AM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:41 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:05 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-11-2016, 01:26 PM
RE: Philco 48-200 Clear but faint - by Tgace459 - 07-21-2016, 07:37 AM
RE: Philco 48-200 Clear but faint - by morzh - 07-21-2016, 01:05 PM



Users browsing this thread: 12 Guest(s)
[-]
Recent Posts
Philco 16B Parts
The 16B's in the tombstone cabinet sport a 10 1/2" spkr vs the older cathedral sets which uses an 8". The p/p ...Radioroslyn — 12:58 AM
Philco 38-7 Oscillation
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 11:16 PM
Philco 38-7 Speaker
I know that when I first started working on this radio, I did not even have a speaker. Once I finally found one it was n...tludka — 11:00 PM
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration