1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
philco470/490
Eliot Ness
Phorum Expert
*****
Posts: 3,135
Threads: 54
Joined: Apr 2011
City: Lexington, KY
#20

07-28-2016, 12:53 AM
The bottom (SW) escutcheon might be hard to find.   If I remember correctly it is different from the 70 or 90 escutcheon because while it looks the same it says "Made in U.S.A." on it.  A regular brass model 70 escutcheon will look pretty good while you search for the correct one.
John KK4ZLF
Lexington, KY
"illegitimis non carborundum"
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 470 - by Radioroslyn - 07-18-2016, 02:32 PM
RE: philco470/490 - by sam - 07-19-2016, 11:15 AM
RE: philco470/490 - by Radioroslyn - 07-19-2016, 02:35 PM
RE: philco470/490 - by sam - 07-19-2016, 03:11 PM
RE: philco470/490 - by mg34.42 - 07-19-2016, 03:24 PM
RE: philco470/490 - by sam - 07-19-2016, 03:39 PM
RE: philco470/490 - by mg34.42 - 07-19-2016, 08:12 PM
RE: philco470/490 - by mg34.42 - 07-19-2016, 08:20 PM
RE: philco470/490 - by Ron Ramirez - 07-19-2016, 08:32 PM
RE: philco470/490 - by mg34.42 - 07-19-2016, 08:51 PM
RE: philco470/490 - by Ron Ramirez - 07-19-2016, 09:45 PM
RE: philco470/490 - by mg34.42 - 07-27-2016, 10:57 PM
RE: philco470/490 - by Eliot Ness - 07-28-2016, 12:53 AM
RE: philco470/490 - by mg34.42 - 07-28-2016, 06:43 AM
RE: philco470/490 - by Ron Ramirez - 07-28-2016, 08:26 AM
RE: philco470/490 - by mg34.42 - 07-28-2016, 09:03 AM
RE: Philco 470 - by Ron Ramirez - 07-18-2016, 03:34 PM
RE: philco470/490 - by mg34.42 - 07-19-2016, 03:22 PM
RE: Philco 470 - by Ron Ramirez - 07-18-2016, 07:09 PM
RE: Philco 470 - by Radioroslyn - 07-18-2016, 07:20 PM
RE: Philco 470 - by Ron Ramirez - 07-18-2016, 07:31 PM
philco470/490 - by mg34.42 - 07-18-2016, 10:08 PM
RE: philco470/490 - by Radioroslyn - 07-19-2016, 06:39 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
trying to identify this wire type
Thanks to all for the feedback. As Arran said, it is probably an older replacement and yes it has a grid cap so I will ...georgetownjohn — 09:32 PM
trying to identify this wire type
It's possible that the red wire, actually a grid cap lead, is a very old replacement, I can't remember seeing a pre 1939...Arran — 09:18 PM
Gilfillan Brothers Car Radio?
Hi everyone,  Special thanks to Joe Rossi for tracking down this obscure radio and thanks to others who took up the hun...Antipodal — 08:15 PM
trying to identify this wire type
Here's one source for your wire of many. Take care and BE HEALTHY! Gary P.S. Can't get the right color you need? I ...GarySP — 06:40 PM
trying to identify this wire type
...and modern wire of the appropriate gauges and insulation V-rating (300V minimum, usually shown right on the wire) is ...morzh — 05:47 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM

[-]
Who's Online
There are currently 3770 online users. [Complete List]
» 1 Member(s) | 3769 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Cabinet Restoration