RCA Victor T-55 AM radio

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

RCA Victor T-55 AM radio

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

#16

07-30-2016, 05:43 PM

Ok, Here we go again.. I was replacing caps and found one cap marked .01 on schematic C15 was really a .0025 at 700 Volts. It goes from Plate of the 6SQ7 to grid of the 6F6.

C13 marked .0025 from Resistor R5 to switch was really a .001 at 1000 Volts.. Question should I change them back to values on schematic? Also do I really need 1000 volt caps. Would 630 Volt work..

[Image: http://i292.photobucket.com/albums/mm38/...v6tr87.jpg]

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

RCA Victor T-55 AM radio - by vecher - 07-17-2016, 05:10 PM

RE: RCA Victor T-55 AM radio - by Radioroslyn - 07-17-2016, 06:19 PM

RE: RCA Victor T-55 AM radio - by vecher - 07-17-2016, 08:10 PM

RE: RCA Victor T-55 AM radio - by Arran - 07-18-2016, 03:25 AM

RE: RCA Victor T-55 AM radio - by vecher - 07-18-2016, 08:59 AM

RE: RCA Victor T-55 AM radio - by vecher - 07-21-2016, 10:23 AM

RE: RCA Victor T-55 AM radio - by KCMike - 07-21-2016, 11:14 AM

RE: RCA Victor T-55 AM radio - by vecher - 07-21-2016, 07:45 PM

RE: RCA Victor T-55 AM radio - by vecher - 07-24-2016, 08:00 PM

RE: RCA Victor T-55 AM radio - by klondike98 - 07-24-2016, 08:13 PM

RE: RCA Victor T-55 AM radio - by Arran - 07-26-2016, 06:53 AM

RE: RCA Victor T-55 AM radio - by vecher - 07-28-2016, 11:34 PM

RE: RCA Victor T-55 AM radio - by Steve Davis - 07-29-2016, 09:34 AM

RE: RCA Victor T-55 AM radio - by vecher - 07-29-2016, 12:12 PM

RE: RCA Victor T-55 AM radio - by vecher - 07-29-2016, 09:02 PM

RE: RCA Victor T-55 AM radio - by vecher - 07-30-2016, 05:43 PM

RE: RCA Victor T-55 AM radio - by Radioroslyn - 07-30-2016, 06:59 PM

RE: RCA Victor T-55 AM radio - by vecher - 07-30-2016, 08:48 PM

RE: RCA Victor T-55 AM radio - by Mitch - 07-31-2016, 12:35 AM

RE: RCA Victor T-55 AM radio - by vecher - 08-02-2016, 08:10 PM

RE: RCA Victor T-55 AM radio - by Radioroslyn - 08-02-2016, 08:27 PM

RE: RCA Victor T-55 AM radio - by vecher - 08-02-2016, 11:28 PM

RE: RCA Victor T-55 AM radio - by vecher - 08-03-2016, 11:39 PM

RE: RCA Victor T-55 AM radio - by vecher - 08-04-2016, 12:30 AM

RE: RCA Victor T-55 AM radio - by vecher - 08-04-2016, 01:21 PM

RE: RCA Victor T-55 AM radio - by Radioroslyn - 08-04-2016, 04:48 PM

RE: RCA Victor T-55 AM radio - by vecher - 08-04-2016, 11:47 PM

RE: RCA Victor T-55 AM radio - by Radioroslyn - 08-08-2016, 06:33 AM

RE: RCA Victor T-55 AM radio - by vecher - 08-07-2016, 10:48 PM

RE: RCA Victor T-55 AM radio - by vecher - 08-08-2016, 09:41 AM

RE: RCA Victor T-55 AM radio - by vecher - 08-08-2016, 11:20 AM

View a Printable Version

Users browsing this thread: 9 Guest(s)

Recent Posts
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM
IF can wire size and Rubber mounts?
A pair of wire strippers can give you an idea of what the existing gauge of the wire leads are in the IF can, I think it...Arran — 06:07 AM
My last cabinet for this year
Hello Dan, That is really beautiful what great looking radio you have ! I have friends who live in Calgary and the wea...radiorich — 01:51 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me