1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Philco 37-650
Oldresistor47
Junior Member
**
Posts: 27
Threads: 4
Joined: Aug 2016
City: Pembroke Pines, FL
#7

08-07-2016, 07:26 PM
Didn't mean to infer just the electrolytics were replaced. All but the mica's were changed out and resistors. Had to replace two tubes but the others checked ok. I'll recheck the transformer, initial checks indicated resistances were within tolerances. I'll replace the 5y4 (rectifier) with another good one and see if that helps. Sounds good at 110v. Nothing is overheating.
Thanks for the help.
Find
« Next Oldest | Next Newest »


Messages In This Thread
Philco 37-650 - by Oldresistor47 - 08-06-2016, 10:22 PM
RE: Philco 37-650 - by Radioroslyn - 08-07-2016, 08:53 AM
RE: Philco 37-650 - by klondike98 - 08-07-2016, 10:14 AM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 06:02 PM
RE: Philco 37-650 - by Radioroslyn - 08-08-2016, 07:23 PM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 06:06 PM
RE: Philco 37-650 - by morzh - 08-07-2016, 06:30 PM
RE: Philco 37-650 - by Oldresistor47 - 08-07-2016, 07:26 PM
RE: Philco 37-650 - by morzh - 08-07-2016, 08:32 PM
RE: Philco 37-650 - by Oldresistor47 - 08-08-2016, 07:24 AM
RE: Philco 37-650 - by Oldresistor47 - 08-08-2017, 06:46 PM
RE: Philco 37-650 - by Oldresistor47 - 08-17-2017, 09:06 PM
RE: Philco 37-650 - by Radioroslyn - 08-17-2017, 10:10 PM
RE: Philco 37-650 - by Oldresistor47 - 08-18-2017, 05:31 AM
RE: Philco 37-650 - by Radioroslyn - 08-18-2017, 11:51 AM
RE: Philco 37-650 - by Oldresistor47 - 08-18-2017, 09:31 PM
RE: Philco 37-650 - by Oldresistor47 - 01-09-2018, 10:34 PM
RE: Philco 37-650 - by Radioroslyn - 01-09-2018, 10:48 PM
RE: Philco 37-650 - by Oldresistor47 - 01-24-2018, 08:14 AM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
I have a question about this radio, is there anyone that has access to this radio that has an intact unmolested speaker ...captainclock1988 — 04:28 PM
1930s Stromberg-Carlson Tombstone Radio need help identifying model number
Well what makes me confuse all of those companies is that all three of those companies (Setchell-Carlson, Stromberg-Carl...captainclock1988 — 04:21 PM
trying to identify this wire type
The red wire is rubber covered wire. The others are cotton braid over rubber often in colors or a tracer, also strand...Chas — 02:43 PM
trying to identify this wire type
Greetings Phorum members, Hope you can help me identify this type of wire in the photo I have attached.  I am not sure ...georgetownjohn — 01:53 PM
Philco 60 Squealing
All correct shields must be in place, all tubes correct no subs of any kind. Check any soldered, riveted ground conne...Chas — 01:24 PM
Philco 60 Squealing
I have recapped and replaced out of tolerance resistors and so on. Radio plays nicely on fairly strong stations. The pro...dconant — 10:55 AM
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM

[-]
Who's Online
There are currently 3782 online users. [Complete List]
» 1 Member(s) | 3781 Guest(s)
Avatar

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration