Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

1935 Philco 45C "Butterfly"
#43

Very nice job Jeff and vintage music as well.
Jerry

A friend in need is a pest!  Bill Slee ca 1970.


Messages In This Thread
1935 Philco 45C "Butterfly" - by PhilcoPhan1936 - 07-01-2016, 09:59 PM
RE: 1935 Philco 45C "Butterfly" - by Arran - 07-02-2016, 04:39 AM
RE: 1935 Philco 45C "Butterfly" - by KCMike - 07-10-2016, 08:55 AM
RE: 1935 Philco 45C "Butterfly" - by morzh - 07-10-2016, 10:59 AM
RE: 1935 Philco 45C "Butterfly" - by morzh - 07-14-2016, 11:00 AM
RE: 1935 Philco 45C "Butterfly" - by Ron Ramirez - 07-14-2016, 08:45 PM
RE: 1935 Philco 45C "Butterfly" - by morzh - 07-18-2016, 08:56 PM
RE: 1935 Philco 45C "Butterfly" - by klondike98 - 07-18-2016, 09:09 PM
RE: 1935 Philco 45C "Butterfly" - by KCMike - 07-18-2016, 09:32 PM
RE: 1935 Philco 45C "Butterfly" - by Ron Ramirez - 08-04-2016, 08:08 PM
RE: 1935 Philco 45C "Butterfly" - by jerryhawthorne - 08-08-2016, 03:56 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

[-]
Who's Online
There are currently 4891 online users. [Complete List]
» 1 Member(s) | 4890 Guest(s)
Avatar

>