[spiderdrummer24]

Using a reproduction escutcheon one has to transfer or replace the white vellum paper and angled metal piece on the back.   When doing mine, I found one of the four drive screws was missing.
The drive screws are tiny ~ 1/16” dia x 3/16” long.

Replacement screws can be purchased @ SpencerAircraft.com
P/N  MS21318-2 or alt part # AN535-00-3

I have now have extras if you need one.
FYI – install hole = .052 diameter, that is a #55 drill

Mine is missing one of the 4 screws as well. I just got the 4 new screws. However I'm wondering how do you get the old screws out without damaging it? And do you just hammer in the new ones after you drill the hole?