which coil - model 52

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

which coil - model 52

Radioroslyn
Phorum Expert

Posts: 7,288
Threads: 268
Joined: Dec 2009
City: Roslyn Pa

#16

08-13-2016, 07:42 PM

SG voltage seem a bit low check #39,40, and 23. If #18 is too high it will cause the plate voltage on the 24 to be too high.

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry

(This post was last modified: 08-13-2016, 07:47 PM by Radioroslyn.)

Find

« Next Oldest | Next Newest »

Messages In This Thread

which coil - model 52 - by winston763 - 08-05-2016, 12:07 AM

RE: which coil - model 52 - by morzh - 08-05-2016, 10:08 AM

RE: which coil - model 52 - by Radioroslyn - 08-05-2016, 10:46 AM

RE: which coil - model 52 - by winston763 - 08-05-2016, 01:14 PM

RE: which coil - model 52 - by morzh - 08-05-2016, 01:41 PM

RE: which coil - model 52 - by Radioroslyn - 08-05-2016, 02:37 PM

RE: which coil - model 52 - by morzh - 08-05-2016, 03:23 PM

RE: which coil - model 52 - by winston763 - 08-07-2016, 12:19 AM

RE: which coil - model 52 - by Radioroslyn - 08-07-2016, 08:25 AM

RE: which coil - model 52 - by morzh - 08-07-2016, 06:03 PM

RE: which coil - model 52 - by winston763 - 08-10-2016, 11:37 PM

RE: which coil - model 52 - by Radioroslyn - 08-11-2016, 06:13 AM

RE: which coil - model 52 - by winston763 - 08-11-2016, 11:34 PM

RE: which coil - model 52 - by Radioroslyn - 08-12-2016, 02:48 AM

RE: which coil - model 52 - by winston763 - 08-13-2016, 06:30 PM

RE: which coil - model 52 - by Radioroslyn - 08-13-2016, 07:42 PM

RE: which coil - model 52 - by winston763 - 08-18-2016, 08:40 PM

RE: which coil - model 52 - by Radioroslyn - 08-19-2016, 07:29 AM

View a Printable Version

Users browsing this thread: 14 Guest(s)

Recent Posts
Rusty Tuning Condenser
Hello Rob. I've also heard of soaking the tuning cap in automatic transmission fluid. This was an old trick we used to...GarySP — 06:14 PM
Rusty Tuning Condenser
Gary, I once had a tuning cap that had a thick coat of kitchen grease and grime. So I had heard about brake cleaner bei...RodB — 06:03 PM
Rusty Tuning Condenser
I've put tuning caps with mica removed and vanes wide open in the dishwasher and ran through a cycle. When the dishwash...GarySP — 05:42 PM
Rusty Tuning Condenser
I do not think Philco 91 used pot metal for the tuning cap. Also, in 1930-s pot metal did not have iron, being mostly co...morzh — 04:56 PM
38-10T chassis Restoration begins
Rich do you dunk the whole razor in there with it turned on to get a good mix? :lol:dconant — 04:48 PM
Rusty Tuning Condenser
David, RodB says to watch out for pot metal as it might dissolve in vinegar. I think there might be some in there. I thi...dconant — 04:40 PM
Rusty Tuning Condenser
Give the tuner a good wash in Dawn and hot water. Then set tuner in a plastic container and cover with vinegar let soak ...David — 12:53 PM
Rusty Tuning Condenser
If you have rust between the vanes, I wonder how you get the NJ in between, and how you then wipe it off.morzh — 12:02 PM
Philco 60 Squealing
If the noise is still there, the OPT might just be OK. Or so we hope.morzh — 12:01 PM
Philco 60 Squealing
You would probably be replacing the OPT.RodB — 10:54 AM

Who's Online

There are currently 3302 online users. [Complete List]
» 1 Member(s) | 3301 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me