Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Knob on 60B Early Version
#1

I have a '35 60B (early version) as noted and pictured in the Gallery (shown below). Don't have a pic of mine that I've refinished handy, but happy to share later.

i'm sure this is my inexperience speaking -- but the 4 matching bakelite knobs that came with the radio purchase were in a separate pouch when I received. Great condition after I polished them. Wasn't until I finished the cabinet and had the chassis restored that I put the knobs on and one doesn't fit -- the hole is quite a bit too large for any of the shafts.

Is this more likely that the shaft has been replaced with a different size or I've got a replacement knob? Knobs match each other perfectly and are obviously vintage (and all have their springs in place). Did they make these knobs with different size shaft openings so I could possibly find a replacement? I plan to sell this radio so want to be authentic with whatever I have to do.

Thanks.

Note from site admin: Sorry, but the photo which was attached to this post is no longer available.

"Ignorance is bliss...'til you have to fix a radio..."


Messages In This Thread
Knob on 60B Early Version - by jayoungs - 08-11-2009, 02:02 PM



Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently no members online.

>