[Ron Ramirez]

I touched up the filled nail holes...

[Image: http://www.philcoradio.com/images/phorum/bozak_044.jpg]

I'm not real happy with it, but I'm not going any further with it other than polishing out the spots once the lacquer fully cures.

So...

That having been done, I turned my attention to reattaching the insulation inside the cabinet tops...

[Image: http://www.philcoradio.com/images/phorum/bozak_045.jpg]

[Image: http://www.philcoradio.com/images/phorum/bozak_046.jpg]

After that, I decided to attack the cabinet backs.

I removed the insulation from each back.

Then, following GarySP's advice, I applied Bondo to the extra holes in the cabinet backs that should not be there.

[Image: http://www.philcoradio.com/images/phorum/bozak_047.jpg]

In a little while, once the Bondo is fully dried, I'll sand down the backs and then reattach the insulation on the inside of the cabinet backs.

The project will then be basically complete.

Now comes installing new wiring from the speaker screw terminals to the 3-way crossovers, and from the crossovers to the speakers. This, of course, goes along with reattaching the speakers inside the cabinets.

Almost there...