NEW: Superior TV-11 Tube Tester

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

NEW: Superior TV-11 Tube Tester

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

09-24-2016, 07:44 PM

Ok, Did my best at calibration. Now when I set the line adjust to the line adjust line it reads the filament voltage setting correctly. When I put in a tube and compensate for the current draw the voltage is right on after readjusting the control..

Tube tester now works correctly..

It will be a great addition to my equipment for testing the older 4 and 5 pin tubes..

It cost a little more than I wanted but at lease it good now..

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

NEW: Superior TV-11 Tube Tester - by vecher - 09-20-2016, 12:08 PM

RE: NEW: Superior TV-11 Tube Tester - by morzh - 09-20-2016, 12:14 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-20-2016, 03:13 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-20-2016, 04:46 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-22-2016, 03:53 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-22-2016, 07:45 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-23-2016, 10:25 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-24-2016, 07:44 PM

RE: NEW: Superior TV-11 Tube Tester - by klondike98 - 09-25-2016, 06:54 PM

RE: NEW: Superior TV-11 Tube Tester - by vecher - 09-25-2016, 09:28 PM

RE: NEW: Superior TV-11 Tube Tester - by morzh - 09-26-2016, 07:20 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Cannot Adjust an IF Transformer’s cores
The abilities of our 'Phorum Pholks" never ceases to amaze me! Fantastic fabrication, Joseph! I'm waiting now for...GarySP — 08:27 PM
PT-6 antenna connections
Thanks. I never realized that was a notch noted in the schematic as described. I’ll recheck my wiring.bridkarl — 08:13 PM
Cannot Adjust an IF Transformer’s cores
Thank you! I was quite new to the Phorum when I started this post, so I feel like it might be advantageous to publish a ...jrblasde — 08:07 PM
PT-6 antenna connections
Notice in the schematic the notch at the bottom of the antenna coil is between pins 3 & 4. Yes, pin 6 of the 7C6 is...RodB — 07:34 PM
bridkarl
I have two PT-6 chassis. On both there is a blue wire that runs from the above chassis transformer to pin 6 of 7C6. So t...bridkarl — 07:23 PM
Cannot Adjust an IF Transformer’s cores
Joseph, now you are an engineer!!RodB — 06:37 PM
PT-6 antenna connections
Hi, reading your explanation I can see the confusion. If you take it one connection at a time it should result in a desi...RodB — 06:34 PM
Cannot Adjust an IF Transformer’s cores
It works! I received the PCBs this morning in the mail, and put everything together. I reused the base from the original...jrblasde — 04:32 PM
PT-6 antenna connections
I seem to have lost my way on this PT-6. I see the antenna aerial transformer schematic - I’m reading pins 1 through ...bridkarl — 12:30 PM
40-150 General questions
Good thing you're a good electrician ... the pictures show a lot of rewiring in your future! Take care and BE HEALTHY!...GarySP — 11:52 AM

Who's Online

There are currently 4121 online users. [Complete List]
» 2 Member(s) | 4119 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me