Philco 46-1209

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco 46-1209

vecher
Phorum Expert

Posts: 933
Threads: 140
Joined: Mar 2015
City: Lansdale State, Province, Country: PA

#17

11-05-2016, 06:34 PM

Ok, Hooked up my Variac to input of transformer.. Measured YEL-YEL on the 5Y3gt tube ( tube was not in place)

At 30 volts in Output was 190 VAC
50 volts in Output was 304 VAC
60 volts in Output was 370 VAC
115 volts in Output was 710 VAC Current draw was 250MA

This is NO LOAD .. Using a Fluke 77 multimeter..

Transformer cool to touch.. Is this in ballpark?

Skip...

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco 46-1209 - by vecher - 10-31-2016, 09:41 PM

RE: Philco 46-1209 - by Arran - 11-01-2016, 05:57 AM

RE: Philco 46-1209 - by vecher - 11-01-2016, 02:21 PM

RE: Philco 46-1209 - by morzh - 11-01-2016, 03:33 PM

RE: Philco 46-1209 - by vecher - 11-01-2016, 08:35 PM

RE: Philco 46-1209 - by vecher - 11-02-2016, 03:59 PM

RE: Philco 46-1209 - by Radioroslyn - 11-02-2016, 05:20 PM

RE: Philco 46-1209 - by Kenneth F. Besso Jr. - 11-02-2016, 07:56 PM

RE: Philco 46-1209 - by Paul Philco322 - 11-02-2016, 08:02 PM

RE: Philco 46-1209 - by vecher - 11-02-2016, 11:41 PM

RE: Philco 46-1209 - by Kestas - 11-03-2016, 10:21 AM

RE: Philco 46-1209 - by vecher - 11-03-2016, 10:30 AM

RE: Philco 46-1209 - by vecher - 11-03-2016, 11:22 AM

RE: Philco 46-1209 - by vecher - 11-04-2016, 03:10 PM

RE: Philco 46-1209 - by Arran - 11-05-2016, 05:14 AM

RE: Philco 46-1209 - by vecher - 11-05-2016, 10:12 AM

RE: Philco 46-1209 - by vecher - 11-05-2016, 06:34 PM

RE: Philco 46-1209 - by Radioroslyn - 11-05-2016, 07:37 PM

RE: Philco 46-1209 - by vecher - 11-05-2016, 06:42 PM

RE: Philco 46-1209 - by vecher - 11-05-2016, 09:08 PM

RE: Philco 46-1209 - by Radioroslyn - 11-05-2016, 10:35 PM

RE: Philco 46-1209 - by vecher - 11-05-2016, 11:53 PM

RE: Philco 46-1209 - by klondike98 - 11-06-2016, 08:41 AM

RE: Philco 46-1209 - by vecher - 11-06-2016, 10:22 AM

RE: Philco 46-1209 - by klondike98 - 11-06-2016, 12:23 PM

RE: Philco 46-1209 - by vecher - 11-06-2016, 12:42 PM

RE: Philco 46-1209 - by vecher - 11-10-2016, 06:09 PM

RE: Philco 46-1209 - by KCMike - 11-10-2016, 06:16 PM

RE: Philco 46-1209 - by Nathan Slingerland - 11-10-2016, 06:16 PM

RE: Philco 46-1209 - by vecher - 11-10-2016, 10:33 PM

RE: Philco 46-1209 - by Radioroslyn - 11-10-2016, 11:28 PM

RE: Philco 46-1209 - by Kestas - 11-11-2016, 12:39 PM

RE: Philco 46-1209 - by vecher - 11-12-2016, 08:47 PM

RE: Philco 46-1209 - by vecher - 11-14-2016, 10:33 PM

RE: Philco 46-1209 - by Radioroslyn - 11-15-2016, 01:09 AM

RE: Philco 46-1209 - by vecher - 11-15-2016, 01:13 AM

View a Printable Version

Users browsing this thread: 4 Guest(s)

Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

Who's Online

There are currently 2907 online users. [Complete List]
» 1 Member(s) | 2906 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me