1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Bakelite Philco Block resistor wattage?
ccomer1955
Senior Member
****
Posts: 264
Threads: 51
Joined: Aug 2014
City: San Antonio, TX
#1

11-13-2016, 09:16 AM
I'm working on this Philco 19 cathedral, and I have a question about C5 which is a Bakelight block part number 4989W according to the parts list on the Philco changes sheet: http://www.philcoradio.com/phorum/attach...?aid=11508

The block in my radio is a 4989AG, but the difference between the two parts seems to be a 300 ohm resistor rather than a 200 ohm resistor. The resistor itself is some looped coated wire in a small paper package. What would be the proper wattage for a replacement? That part is between the cathode of the output tube and the cathode of the IF tube and ground.


http://www.philcoradio.com/images/phorum/19v6.jpg
Charlie in San Antonio
Find
« Next Oldest | Next Newest »


Messages In This Thread
Bakelite Philco Block resistor wattage? - by ccomer1955 - 11-13-2016, 09:16 AM



Users browsing this thread: 3 Guest(s)
[-]
Recent Posts
Philco 46-420 Code 121 Reception issues
Welcome Eric, I agree with Bob and far as the two main electrolytic filter capacitors did you change them yourself or w...radiorich — 11:43 PM
Philco 46-420 Code 121 Reception issues
You mentioned the Philco manual and going through the check points...just to be sure we're on the same page here's the m...klondike98 — 08:13 PM
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration