1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
Inoperable tone controls
Radioroslyn
Phorum Expert
*****
Posts: 7,285
Threads: 268
Joined: Dec 2009
City: Roslyn Pa
#13

11-16-2016, 12:07 AM
c-201 is open replace it. Check for -11vdc on grid of 6SQ7 and a good gnd connection on pin 3. If this doesn't lower your plate voltage try another 6SQ7.
When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry
(This post was last modified: 11-16-2016, 12:24 AM by Radioroslyn.)
Find
« Next Oldest | Next Newest »


Messages In This Thread
Inoperable tone controls - by lasurveyor - 11-15-2016, 03:44 PM
RE: Inoperable tone controls - by klondike98 - 11-15-2016, 07:11 PM
RE: Inoperable tone controls - by lasurveyor - 11-15-2016, 08:12 PM
RE: Inoperable tone controls - by lasurveyor - 11-15-2016, 08:24 PM
RE: Inoperable tone controls - by Jim Koehler - 11-15-2016, 07:28 PM
RE: Inoperable tone controls - by lasurveyor - 11-15-2016, 08:27 PM
RE: Inoperable tone controls - by Radioroslyn - 11-15-2016, 09:24 PM
RE: Inoperable tone controls - by Radioroslyn - 11-15-2016, 09:40 PM
RE: Inoperable tone controls - by lasurveyor - 11-15-2016, 10:39 PM
RE: Inoperable tone controls - by Radioroslyn - 11-15-2016, 10:56 PM
RE: Inoperable tone controls - by lasurveyor - 11-15-2016, 11:25 PM
RE: Inoperable tone controls - by klondike98 - 11-15-2016, 09:41 PM
RE: Inoperable tone controls - by Radioroslyn - 11-16-2016, 12:07 AM
RE: Inoperable tone controls - by lasurveyor - 11-16-2016, 02:10 AM



Users browsing this thread: 5 Guest(s)
[-]
Recent Posts
Philco 42-1008 conversion kit
Interesting. I haven't seen that before.klondike98 — 07:02 PM
12' Philco
Yes I had looked for it on the web as well some time back and could not find it. I was glad to see it turned up in Ron'...klondike98 — 06:59 PM
Shadow Meter Bulb
Now if you had a set with a tuning light then the bulb type is important to the circuit, some sets used those prior to t...Arran — 04:58 PM
Shadow Meter Bulb
Ok. Thanks for the correction.RossH — 03:09 PM
Model 28L
For 28 you will probably need to buy a Hammond 125CSE. Or any of the series of the power you need, with SE suffix. Then ...morzh — 02:09 PM
37-60 revision 6
I am restoring a Philco 37-60 and it shows run 6 they removed the ground from G3 of the 6K7G and put the G3 to -2.5v for...bobbyd1200 — 01:01 PM
Shadow Meter Bulb
Mike is correct on the bulb connection, two separate circuits. I found that by rotating the bulb and sliding it forward ...RodB — 12:19 PM
Hickok AC51 tube tester
Cleaned ann contacts, switches and sockets, works great now.martinj — 11:32 AM
Model 28L
Hello, I'm restoring a Philco 28L and the output transformer is open. Part number of the transformer is 32-7020. Can...HORSTE — 10:32 AM
Philco 42-1008 conversion kit
I read about a kit to convert the variable speed changer in the Philco 42-1008 into a single speed unit.  That would rem...alangard — 09:30 PM

[-]
Who's Online
There are currently no members online.

>
  1. The PHILCO Phorum
  2. Philco Radio Discussions
  3. Philco Electronic Restoration