Philco ID

Thread Rating:

Philco ID

Ron Ramirez
Silent Key

Posts: 13,776
Threads: 580
Joined: Sep 2005
City: Ferdinand State, Province, Country: Indiana

11-27-2016, 06:43 PM

Yup...the final version of model 60 Baby Grand from mid-season 1936.

Nice and clean. Icon_thumbup

Get a shield on that 78 tube before you fire it up, else it will squeal like crazy.

--
Ron Ramirez
Ferdinand IN

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco ID - by vecher - 11-27-2016, 04:15 PM

RE: Philco ID - by Ron Ramirez - 11-27-2016, 06:43 PM

RE: Philco ID - by vecher - 11-27-2016, 09:08 PM

RE: Philco ID - by klondike98 - 11-28-2016, 08:23 AM

RE: Philco ID - by vecher - 11-28-2016, 12:21 PM

RE: Philco ID - by vecher - 11-30-2016, 02:16 PM

RE: Philco ID - by Ron Ramirez - 11-30-2016, 03:24 PM

RE: Philco ID - by vecher - 12-08-2016, 10:17 PM

RE: Philco ID - by vecher - 12-09-2016, 01:15 AM

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM
Philco 60 Squealing
Litz is typically tinned by simply rubbing it with the soldering iron tip while immersed in solder (and a bit of rosin f...morzh — 05:14 PM
Philco 6K7
The suppressor grid (if by G3 you mean the S) is usually at the Cathode potential, which in this caes is GND. I am not ...morzh — 05:10 PM
Philco 16B Parts
Thanks for the reply. Unfortunately the radio was removed before bidding was over so I didn't get a chance to bid.dconant — 04:10 PM

Who's Online

There are currently 4764 online users. [Complete List]
» 2 Member(s) | 4762 Guest(s)