Philco ID

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Philco ID

Nathan Slingerland
Super Moderator

Posts: 1,874
Threads: 212
Joined: May 2015
City: Seattle State, Province, Country: WA

11-30-2016, 02:31 PM

The 110pF should be replaced with mica caps. 500V should be fine.

I believe they may be mica caps to begin with (encased in tar), but I usually replace them with new caps just to be sure.

I'll let others reply on the other questions.

Find

« Next Oldest | Next Newest »

Messages In This Thread

Philco ID - by vecher - 11-27-2016, 04:15 PM

RE: Philco ID - by Nathan Slingerland - 11-27-2016, 04:17 PM

RE: Philco ID - by Ron Ramirez - 11-27-2016, 06:43 PM

RE: Philco ID - by vecher - 11-27-2016, 09:08 PM

RE: Philco ID - by klondike98 - 11-28-2016, 08:23 AM

RE: Philco ID - by vecher - 11-28-2016, 12:21 PM

RE: Philco ID - by vecher - 11-30-2016, 02:16 PM

RE: Philco ID - by Nathan Slingerland - 11-30-2016, 02:31 PM

RE: Philco ID - by Ron Ramirez - 11-30-2016, 03:24 PM

RE: Philco ID - by vecher - 12-08-2016, 10:17 PM

RE: Philco ID - by vecher - 12-09-2016, 01:15 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 60 Squealing
I seem to remember eliminating a squeal by changing the IF frequency by a few KHz. Not that you should put too much tru...fenbach — 08:48 PM
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone, As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic. This radio had a 8" Zenith speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM

Who's Online

There are currently 5422 online users. [Complete List]
» 1 Member(s) | 5421 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me