Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Philco 48-460 restoration
#3

SO did you put a cord on and let her rip????????   [Image: http://philcoradio.com/phorum/images/smi...roblem.gif]

signed
Terry the troublemaker

When my pals were reading comic books
I was down in the basement in my dad's
workshop. Perusing his Sam's Photofoacts
Vol 1-50 admiring the old set and trying to
figure out what all those squiggly meant.
Circa 1966
Now I think I've got!

Terry


Messages In This Thread
Philco 48-460 restoration - by Bob Andersen - 12-01-2016, 06:03 PM
RE: Philco 48-460 restoration - by Bob Andersen - 12-01-2016, 06:13 PM
RE: Philco 48-460 restoration - by Radioroslyn - 12-01-2016, 06:15 PM
RE: Philco 48-460 restoration - by Bob Andersen - 12-01-2016, 06:28 PM
RE: Philco 48-460 restoration - by klondike98 - 12-01-2016, 07:04 PM
RE: Philco 48-460 restoration - by Paul Philco322 - 12-01-2016, 08:54 PM
RE: Philco 48-460 restoration - by Bob Andersen - 01-05-2017, 07:00 PM
RE: Philco 48-460 restoration - by Bob Andersen - 01-17-2017, 02:38 PM
RE: Philco 48-460 restoration - by Bob Andersen - 01-19-2017, 01:48 PM
RE: Philco 48-460 restoration - by Bob Andersen - 01-19-2017, 02:18 PM



Users browsing this thread: 1 Guest(s)
[-]
Recent Posts
Philco 42-390, code 121 speaker
These speakers pop up on eBay regularly, even if at bloated prices. Honestly, have not seen many parts on swapmeets.morzh — 08:38 PM
Philco 38-7 Speaker
The put-put is not like the speaker problem.morzh — 08:29 PM
Mission Bell Model 19A Car Radio
Hello everyone,  As mentioned in my last post I was going to see if the vibrator / rectifier section could be persuaded...Antipodal — 08:21 PM
Philco 60 Squealing
Wondering if I did it backwards. If a coil was wound backwards, the oscillator would not work at all. Old school...Chas — 07:23 PM
Philco 38-7 Speaker
4-ohm speaker. Black, Green leads.tludka — 07:00 PM
Philco 42-390, code 121 speaker
#87 on the schematic.  This radio had a 8" Zenith  speaker attached to it when I got it. I do don't know the hist...Stevelog — 06:39 PM
Philco 60 Squealing
I'm pretty sure I now have the litz wire soldered. This did not make any difference. Back in April I rewound the seconda...dconant — 06:25 PM
Philco 38-7 Speaker
Just to make sure, you chose either 4 ohm into 5K or into 10K? (blk-org or blk-grn)morzh — 06:23 PM
Philco 38-7 Speaker
I have let this one sit because of other duties. Now I am back, and I have a couple of questions. I hooked up a Hammond ...tludka — 05:34 PM
Philco 42-390, code 121 speaker
>>A closer examination of the very small print schematic indicates that the speaker is a PM type. This shows a ...morzh — 05:18 PM

[-]
Who's Online
There are currently 5184 online users. [Complete List]
» 1 Member(s) | 5183 Guest(s)
Avatar

>