Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

38-93.....so far
#22

those rewinds look great! so how did you do them? I have an IF coil that could do with a rewind but was reluctant to give it a try.

thanks!


Messages In This Thread
38-93.....so far - by Greenhorn - 11-17-2016, 01:17 PM
RE: 38-93.....so far - by Nathan Slingerland - 11-17-2016, 03:25 PM
RE: 38-93.....so far - by Greenhorn - 11-18-2016, 09:28 AM
RE: 38-93.....so far - by Greenhorn - 11-17-2016, 04:27 PM
RE: 38-93.....so far - by morzh - 11-17-2016, 07:28 PM
RE: 38-93.....so far - by klondike98 - 11-17-2016, 08:00 PM
RE: 38-93.....so far - by morzh - 11-17-2016, 08:27 PM
RE: 38-93.....so far - by Ron Ramirez - 11-17-2016, 09:32 PM
RE: 38-93.....so far - by KCMike - 11-17-2016, 09:51 PM
RE: 38-93.....so far - by Greenhorn - 11-17-2016, 10:07 PM
RE: 38-93.....so far - by Greenhorn - 11-17-2016, 10:10 PM
RE: 38-93.....so far - by Greenhorn - 11-18-2016, 01:21 PM
RE: 38-93.....so far - by KCMike - 11-18-2016, 01:26 PM
RE: 38-93.....so far - by Greenhorn - 11-18-2016, 01:30 PM
RE: 38-93.....so far - by PhilcoMike - 11-18-2016, 03:42 PM
RE: 38-93.....so far - by Greenhorn - 11-25-2016, 08:28 PM
RE: 38-93.....so far - by morzh - 11-25-2016, 08:41 PM
RE: 38-93.....so far - by Greenhorn - 11-25-2016, 09:20 PM
RE: 38-93.....so far - by PhilcoJohn - 11-26-2016, 06:14 PM
RE: 38-93.....so far - by Greenhorn - 11-26-2016, 10:25 PM
RE: 38-93.....so far - by Greenhorn - 12-05-2016, 02:19 PM
RE: 38-93.....so far - by klondike98 - 12-05-2016, 04:47 PM
RE: 38-93.....so far - by Greenhorn - 12-05-2016, 05:42 PM
RE: 38-93.....so far - by Greenhorn - 12-06-2016, 02:07 PM
RE: 38-93.....so far - by Greenhorn - 02-15-2017, 02:00 PM
RE: 38-93.....so far - by morzh - 02-15-2017, 02:36 PM
RE: 38-93.....so far - by Greenhorn - 02-15-2017, 02:40 PM
RE: 38-93.....so far - by KCMike - 02-15-2017, 03:47 PM
RE: 38-93.....so far - by Greenhorn - 02-15-2017, 07:57 PM
RE: 38-93.....so far - by Greenhorn - 03-17-2017, 02:24 PM
RE: 38-93.....so far - by Kenneth F. Besso Jr. - 03-17-2017, 11:01 PM
RE: 38-93.....so far - by Greenhorn - 03-18-2017, 03:41 PM
RE: 38-93.....so far - by morzh - 03-18-2017, 10:18 AM
RE: 38-93.....so far - by Greenhorn - 07-03-2017, 07:27 AM
RE: 38-93.....so far - by morzh - 07-03-2017, 07:28 AM
RE: 38-93.....so far - by Greenhorn - 07-03-2017, 08:45 AM
RE: 38-93.....so far - by Nathan Slingerland - 07-03-2017, 09:17 AM
RE: 38-93.....so far - by rfeenstra - 12-07-2017, 08:03 PM
RE: 38-93.....so far - by Ron Ramirez - 12-07-2017, 08:18 PM
RE: 38-93.....so far - by Kenneth F. Besso Jr. - 12-08-2017, 08:16 PM



Users browsing this thread: 2 Guest(s)
[-]
Recent Posts
Jackson 715 not working
Now that you posted the schematic, I don't know why that Sprague electrolytic cap is across the meter, as it is not indi...MrFixr55 — 05:51 PM
HiFi (Chifi) tube amp build - but my own design.
What may be lacking in the PP Tube amps may be the 2nd harmonics, which some, especially RCA back in the day called &quo...MrFixr55 — 05:32 PM
Jackson 715 not working
Usually in an emission tester, the tube under test is measured as if it were a diode. So, some testers connect all the g...RodB — 04:17 PM
Restoring Philco 37-604C
Yep. F5 is green, D5 is Red. Red is Bad. Green is Clean.morzh — 01:30 PM
Jackson 715 not working
I did start to do that but I stalled out because I could not figure out how the grid and plate get voltage. In this diag...daveone23 — 11:52 AM
Restoring Philco 37-604C
(Insert Homer Simpson "DOPF" Here.) When all fails, look at the can. Took the Ron Ramirez advice, red Caig D...MrFixr55 — 09:23 AM
Philco 91 Speaker Replacement
From your text I am not sure if you intend to use the existing speaker with a resistor instead of the field coil. It wo...morzh — 08:44 AM
Philco 91 Speaker Replacement
My field coil is bad. I am still hoping to find an original, but if I can't I will go with a fitting Philco speaker, 125...dconant — 08:34 AM
Philco 91 Speaker Replacement
As Rod said, it is OK to use a fitting speaker, and then look for an original one. If you buy a Hammond 125 output tr...morzh — 08:15 AM
Philco 91 Speaker Replacement
Yes, I often have to substitute, then keep an eye out for an original. In the meantime, the radio is working and being e...RodB — 08:02 AM

[-]
Who's Online
There are currently 5369 online users. [Complete List]
» 1 Member(s) | 5368 Guest(s)
Avatar

>