42-321 model variations, schematic needed

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Guest
Unregistered

10-30-2009, 04:47 PM

The schematic on Rider 14-19 is a close match to my 42-321 Code 121. Also, the parts list and parts placement diagram on the same page matches my radio. Of course, your's could be the variation.

Good luck,
Perry

« Next Oldest | Next Newest »

Messages In This Thread

42-321 model variations, schematic needed - by FStephenMasek - 10-08-2009, 10:18 PM

Re: 42-321 model variations, schematic needed - by Sean - 10-09-2009, 06:50 PM

Re: 42-321 model variations, schematic needed - by Guest - 10-30-2009, 04:47 PM

Re: 42-321 model variations, schematic needed - by FStephenMasek - 11-08-2009, 06:11 PM

Re: 42-321 model variations, schematic needed - by PTurney - 11-09-2009, 10:17 AM

Re: 42-321 model variations, schematic needed - by FStephenMasek - 11-11-2009, 10:06 PM

Re: 42-321 model variations, schematic needed - by Joe Rossi - 11-11-2009, 10:12 PM

Re: 42-321 model variations, schematic needed - by FStephenMasek - 11-12-2009, 12:20 PM

View a Printable Version

Users browsing this thread: 1 Guest(s)

Recent Posts
Philco 41-608 changer coupler
3D-printing...short of machining, of course. Or molding.morzh — 05:20 PM
Philco 41-608 changer coupler
Thanks, Morzh. That solves the issue of the rubber pieces. Now, I need to find a way to replicate the pot metal piec...alangard — 05:07 PM
12' Philco
If it is 12', either Kareem or Andre would have to jump pretty high to look at the front panel. Kareem would have an e...morzh — 01:48 PM
12' Philco
And here's a story about the tires on the truck. Same "no-stoop" guy must have installed these! Take care a...GarySP — 01:17 PM
Hickok AC51 tube tester
I think they have only shown the secondaries of the transformer. Two of them feed the rectifiers' filaments.morzh — 12:58 PM
IF can wire size and Rubber mounts?
Arran If the wire inside cans is the gauges you mentioned, the sole reason for that would be mechanical, to stiffen t...morzh — 12:56 PM
12' Philco
Rod, Yes, I know, but the Giant Philco is not around anymore either, so I go by whoever was alive fairly recently. H...morzh — 12:54 PM
Hickok AC51 tube tester
Absolutely no one is going to reverse engineer that circuit. Even the iron core is missing.RodB — 10:37 AM
IF can wire size and Rubber mounts?
Thanks to both members for your help regarding wire and tuner mtg supports. regards--Johngeorgetownjohn — 09:33 AM
Hickok AC51 tube tester
Note that no power cord, power switch, or power transformer switch are shown. That (along with my experience with full s...DaleHCook — 07:09 AM

Who's Online
There are currently no members online.

Login
Username:
Password:	Lost Password?
	Remember me