Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

capacitor question?
#4

Please don't give up so easily. I've been tinkering with this stuff part time for over 40 years on an off, and there's a set on my bench that has been eluding me for a month! As suggested, before, measure the resistors and double check your connections. Part of this hobby is being a detective. Sometimes when you solder in a new component, you can cause a resistor that was probably out of tolerance anyway to open up. They cost less than a dime each to replace anyway.

We'll help you if you want to continue!


Messages In This Thread
capacitor question? - by Guest - 10-31-2009, 04:51 PM
Re: capacitor question? - by Alan Douglas - 10-31-2009, 08:18 PM
Re: capacitor question? - by Guest - 11-01-2009, 07:03 AM
Re: capacitor question? - by codefox1 - 11-01-2009, 12:26 PM
Re: capacitor question? - by Guest - 11-01-2009, 04:02 PM
Re: capacitor question? - by gary rabbitt - 11-07-2009, 12:04 AM
Re: capacitor question? - by Guest - 11-11-2009, 01:39 PM
Re: capacitor question? - by Alan Douglas - 11-12-2009, 04:22 PM
Re: capacitor question? - by Guest - 11-17-2009, 02:28 PM
Re: capacitor question? - by exray - 11-19-2009, 07:02 AM
Re: capacitor question? - by Ron Ramirez - 11-19-2009, 08:44 AM



Users browsing this thread:
[-]
Recent Posts
Philco 91 Speaker Replacement
The spider is glued on the cone and so is the voice coil. I think you can use a cotton swab dipped in acetone and carefu...RodB — 02:42 PM
Restoring Philco 37-604C
Yes I saw that. If I knew, I'd probably try to arrange for getting it myself. But I have just got one. Which does not m...morzh — 01:44 PM
Philco 38-2 Automatic Tuning
When you push the lever, you are supposed to rotate the disk to the desired station. Then the magnetic tuning will acqu...morzh — 01:42 PM
Philco 38-2 Automatic Tuning
I figure out the muting from another picture that helped. Now I need to know how the automatic tuning works. When I push...dconant — 12:11 PM
Philco 91 Speaker Replacement
How would I go about removing the spider from the cone?dconant — 12:04 PM
Philco 38-2 Automatic Tuning
Hello, I am having trouble getting my automatic tuning to stay unmuted. If I play with the tuning handle I can get it to...dconant — 10:51 AM
Does anyone make photofinish replacements?
Here’s the link to the DIY photofinish section of our site: klondike98 — 09:46 AM
Delco car radio Peko vibrator converstion issues
Hi Richard, Thx for posting the schematic.  As I remember as a kid, these were great performers for the time, likely...MrFixr55 — 08:56 AM
Delco car radio Peko vibrator converstion issues
hello mr Fixr, The Electro  Powersupply that I am powering the radio with has a huge choke plus a 10,000ufd electrolyti...radiorich — 10:58 PM
Delco car radio Peko vibrator converstion issues
How about putting a choke in the power supply? The big cap was likely an attempt to stabilize the DC. Kids who cre...MrFixr55 — 09:19 PM

[-]
Who's Online
There are currently 2954 online users. [Complete List]
» 1 Member(s) | 2953 Guest(s)
Avatar

>